Loading ...
Loading ...
Loading ...
To attach the loop handle
1. Attach the loop handle onto the shaft between the
arrows.
2. Move the spacer into the slot of the loop handle.
3. Install the nut, the knob and the bolt. Do not tighten
the bolt fully.
4. Adjust the product to a correct position.
5. Tighten the bolt.
To assemble the two-piece shaft
1. Turn the knob to loosen the coupling.
2. Align the tab of the cutting attachment (A) with the
arrow of the coupling (B).
A
B
3. Carefully push the shaft into the coupling until you
hear a click.
4. Tighten the knob fully.
To disassemble the two-piece shaft
1. Turn the knob 3 turns or more to loosen the
coupling.
2. Push and hold the button (C).
3. Hold tight to the end of the shaft that the engine is
attached to.
4. Pull the attachment straight out of the coupling.
C
To assemble the cutting attachment guard and
trimmer head
1. Attach the correct cutting attachment guard (A) for
the trimmer head. Refer to
Accessories on page 21
.
2. Put the cutting attachment guard onto the fitting on
the shaft.
10
331 - 012 - 25.09.2023
Loading ...
Loading ...
Loading ...