Loading ...
Loading ...
Loading ...
EN
21
CLEANING THE STEAM WAND
• The steam wand should always be cleaned after
texturing milk. Wipe the steam wand with a damp
cloth.
• After use, it is recommended to purge the steam
wand for a couple of seconds, to clear any
remaining milk. With the steam wand positioned
down over the drip tray, turn the STEAM dial to
for a couple of seconds allow the machine
to create steam for a couple of seconds before
turning it back to the vertical position.
• If the steam tip hole becomes blocked, it will
reduce frothing performance. Use the provided
steam wand cleaning tool to clear the opening.
• If the steam wand is still blocked, use the spanner
in the middle of the steam wand cleaning tool to
unscrew the tip. Soak the tip in hot water before
using the cleaning tool to unblock again. Replace
the tip back on the steam wand, using the tool.
CLEANING THE FILTER BASKETS
AND PORTAFILTER
• The lter baskets and portalter should be rinsed
under hot water immediately after use to remove
all residual coee oils.
• If any of the holes in the lter basket become
blocked, use the pin on the end of the provided
cleaning tool to unblock the holes.
• If the holes remain blocked, dissolve a cleaning
tablet in hot water and soak lter basket and
portalter in solution for approx. 20 minutes.
Rinse thoroughly.
CLEANING THE GROUP HEAD
• The group head interior and shower screen
should be wiped with a damp cloth after use to
remove any ground coee particles.
• Periodically purge the machine. Place an empty
lter basket and portalter into the group head.
Press the 1 CUP button and run a short ow of
water to rinse out any residual coee. Press the
1 CUP button again to stop the hot water.
Remove the portalter and rinse thoroughly.
CLEANING THE DRIP TRAY
1. The drip tray should be removed, emptied
and cleaned at regular intervals, particularly
when the drip tray full indicator is showing
EMPTY ME!
2. Remove the drip tray from the machine and
separate the parts. The EMPTY ME! indicator
can also be removed from the drip tray by
pulling upwards to release the side latches.
Wash all parts in warm soapy water with a
soft cloth. Rinse and dry thoroughly before
reassembling and attaching to the machine.
3. The storage tray (located behind the drip tray)
can be removed and cleaned with a soft,
damp cloth.
NOTE
All parts should be cleaned by hand using
warm water and a gentle dish washing liquid.
Do not use abrasive cleansers, pads or cloths
which can scratch the surface. Do not clean any
of the parts or accessories in the dishwasher.
WARNING
Do not immerse the power cord, power plug
or appliance in water or any other liquid.
CLEANING THE OUTER HOUSING
Wipe the outer housing with a soft, damp cloth
and then polish with a soft, dry cloth.
STORING YOUR MACHINE
Before storing, press the POWER button to
turn the machine o then turn o and remove
the plug from the power outlet. Remove unused
beans from the hopper, clean the grinder (see
page 20), empty the water tank and the drip
tray. Ensure the machine is cool, clean and dry.
Place accessories in the storage tray.
Store the machine upright and do not store
anything on top.
ERROR MODE
If your machine displays on the LCD, contact
Sage Customer Service.
Loading ...
Loading ...
Loading ...