Loading ...
Loading ...
Loading ...
19
2. To activate the lter, run tap water through the hole in the
centre of the lter until water comes out of the openings
at the side for more than a minute;
3. Extract the water tank
and ll with water; insert the lter
in the water tank and immerse it completely for about ten
seconds, sloping it and pressing it lightly to enable the air
bubbles to escape;
4. Insert the lter in the lter housing and press as far as
it will go;
5. Close the tank with the lid, then put the tank back in the
machine;
6. Place an empty container with a minimum capacity of 0.5
litres under the steam/hot water spout.
7. See instructions in section “9. Settings menu” to install the
lter.
8. The appliance delivers hot water, then stops automatically;
9. The lter is now active and you can use the coee
machine.
7.1 Replacing the lter
Replace the lter when the corresponding light
comes on.
1. Extract the water tank and exhausted lter;
2. Follow the operations described in the previous section to
activate the lter;
3. See instructions in section “9. Settings menu” to set the
machine.
Please note:
After two months (see date indicator) or when the appliance
has not been used for 3 weeks, you should replace the lter
even if the message has not yet been displayed.
7.2 Removing the lter
If you want to use the appliance without the lter, you must
remove it and notify the appliance of its removal.
1. Extract the water tank and exhausted lter;
2. See instructions in section “9. Settings menu” to set the
machine.
Please note!
After two months (see date indicator) or when the appliance has
not been used for 3 weeks, you should replace the lter even if the
message has not yet been displayed.
8. TIPS FOR ENERGY SAVING
• Set auto-o to 15 minutes (see “9. Settings menu”);
• Enable Energy Saving (see “9. Settings menu”);
• Always carry out the descaling cycle when prompted by
the machine.
Loading ...
Loading ...
Loading ...