Loading ...
Loading ...
Loading ...
English 87
To Replace the Steam Oven Light Bulb
Heat-resistant 120V / 25 Watt halogen bulbs with seals can
be purchased through retail stores or customer service.
When purchasing through customer service provide the
appliance model and serial numbers.
1. Turn off power to the appliance at the main power
supply (breaker box) or unplug the power cord.
2. Turn the cover to the left to remove.
3. Remove the bulb by grasping and sliding the bulb
straight back.
4. Do not touch the glass of the new replacement bulb
with your fingers. It may cause the bulb to fail when it
first lights. Grasp the replacement bulb with a clean dry
cloth. Locate the two prongs in the ceramic holder,
gently poking until the two prongs locate in the ceramic
socket.
5. Ensure the seals and tension ring are returned to the
glass cover.
6. Screw the glass cover with seals back on.
7. Reconnect the appliance to power and reset the clock.
Never operate the appliance without the glass cover or
seals.
Replacing the Glass Cover or Seals
Damaged glass covers or seals must be replaced.
Replacement glass covers or seals may be purchased from
customer service. Provide customer service with the
appliance model and serial numbers.
Power Failure
In the event of a power failure, only the non ExtraLow
®
burners can be lit manually. It is necessary to light each
standard STAR
®
burner individually.
If the range's cooktop is being used when the power failure
occurs, turn all of the STAR burner control knobs to the
OFF position. The standard STAR burners can be lit by
holding a match at the ports and turning the control knob to
the HI position. Wait until the flame is burning all the way
around the STAR burner cap before adjusting the flame to
the desired height.
The four ExtraLow STAR burners on the outer sides cannot
be used during a power failure. Be sure to turn them OFF if
a power failure occurs because they will not turn back on
until the control knobs are turned OFF and then turned
back on again. See “WHAT TO DO IF YOU SMELL GAS”
on page 3.
If you have low gas pressure, contact your gas company.
Intermittent or Constant Igniter Sparking
Intermittent or constant sparking of the sealed gas surface STAR burners can result from a number of preventable
conditions. Eliminate these conditions as indicated in the following chart.
Figure 43: Steam Oven Lamp Assembly
SYMPTOM CAUSE REMEDY
Intermittent sparking Ceramic igniter is wet or dirty.
STAR burner ports are clogged.
Carefully dry or clean igniter.
Clean ports on STAR burner cap with a
wire, a needle or straightened paper clip.
More than four clicks of
igniter before lighting
Improper fit of STAR burner cap
onto STAR burner base.
Align STAR burner cap properly on
STAR burner base.
Constant Sparking Range is not properly grounded. Refer to Installation Instructions. Have a
qualified electrician ground the range
properly.
Electrical power supply is
incorrectly
polarized.
Refer to the Installation Manual.
Have a qualified electrician ground the
range properly.
Loading ...
Loading ...
Loading ...