Loading ...
Loading ...
Loading ...
5. Plug the lower end of the Upright Wire Harness (12) into the 20"
Wire Harness (45). The small latch on the Upright Wire
•Harness should snap onto the 20" Wire Harness (see the upper
inset drawing). If the Wire Harnesses do not fit easily, turn
them; do not force the Wire Harnesses together.
Adjustthe 6" Cable Loom (30) so that the Cable Loom is insert-
ed into the Right Upright (15) and the Rear Safety Cover (52)
(see the lower inset drawing). Be careful not to damage the
Wire Harnesses.
12
52
6. Press the Belt Tool (86) into the opening in the Left Rear
Endcap (82). The Belt Tool is used to center the Walking Belt
(see SYMPTOM 6 on page 14).
86
7. The use of the Pulse Sensor is explained on page 8.
Make sure that all parts are tightened I_efore using the treadmill.
Note: To protect the floor, a covering should be placed under
the treadmill.
7
7
Loading ...
Loading ...
Loading ...