1. Home
  2. Dewalt
  3. Dewalt DWE43265N User Manual
  4. Page 10

Dewalt DWE43265N 5 in. / 6 in. Brushless Small Angle Grinder, Rat Tail with KICKBACK BREAK, No Lock-On

Instructional Manual - Page 10

For DWE43265N.

PDF File Manual, 48 pages, Read Online | Download pdf file

Loading ...
Loading ...
Loading ...
English
8
Fig. C
7
21
12
One-Touch
TM
Two-Touch
TM
setting guard Adjustment Options
To adjust the guard release lever
7
for desired
adjustmentoption:
1. Remove screw
21
using a T20bit.
2. Remove the guard release lever taking note of the
spring position. Choose the end of the lever for the
desired adjustment option. One-touch will use the
slanted end of the lever
7
to engage the alignment
holes
13
on the guard collar. Two-touch will use the
squaredend to engage the alignment holes
13
on the
guardcollar.
3. Replace the lever, positioning the chosen end under the
spring
12
. Ensure the lever is in proper contact with
thespring.
4. Replace screw and torque to 2.0-3.0N-m. Ensure proper
installation with spring return function by depressing
guard release lever
7
.
Mounting guard (Fig. D)
CAUTION: Prior to mounting guard, ensure the screw,
lever, and spring are fitted correctly before mounting
theguard.
1. With the spindle facing the operator, press and hold the
guard release lever
7
.
2. Align the lugs
14
on the guard with the slots
15
on
the gearcasecover.
3. Push the guard down until the guard lugs engage
and rotate them in the groove on the gear case cover.
Release the guard releaselever.
To position the guard:
One-touch
TM
: Rotate the guard clockwise into the
desired working position. Press and hold the guard
release lever
7
to rotate the guard in the counter-
clockwisedirection.
Two-touch
TM
: Press and hold the guard release
lever
7
. Rotate the guard clockwise or counter-
clockwise into the desired working position.
nOTE: The guard body should be positioned between
the spindle and the operator to provide maximum
operatorprotection.
The guard release lever should snap into one of the
alignment holes
13
on the guard collar. This ensures
that the guard issecure.
4. To remove the guard, follow steps 1–3 of these
instructions inreverse.
Fig. D
13
15
14
7
Flanges and Wheels
CAUTION: Turn unit off and unplug the tool before
making any adjustments or removing or installing
attachments oraccessories.
Mounting Non-Hubbed Wheels (Fig. E)
WARNING: Failure to properly seat the flanges and/or
wheel could result in serious injury (or damage to the
tool orwheel).
CAUTION: Included flanges must be used with
depressed center Type 27/42 grinding wheels and
Type1/41 cutting wheels. See the Accessories Chart
for moreinformation.
WARNING: A closed, two-sided cutting wheel guard
is required when using abrasive cutting wheels or
diamond coated cutting wheels.
WARNING: Use of a damaged flange or guard or fail-
ure to use proper flange and guard can re sult in injury
due to wheel breakage and wheel contact. See the
Accessories Chart for moreinformation.
1. Place the tool on a table, guardup.
2. Install the unthreaded backing flange
3
on spindle
1
with the raised center (pilot) facing the wheel.
3. Place wheel
17
against the backing flange,
centering the wheel on the raised center (pilot) of the
backingflange.
Loading ...
Loading ...
Loading ...