Register your product and get support at：
www.philips.com/support
User manual
R3306
3000 Series
Clock Radio
Connect power
1
EN
Contents
1 Important 2
Safety
Notice
2
2
2 Your clock radio
3
Introduction 3
What's in the box 3
Overview of the clock radio 3
3 Get started 4
Install batteries 4
4
Set time
4
4 Listen to FM radio 5
Tune to FM radio stations
Select a preset radio station
5
Store FM radio stations automatically
5
5
Store FM radio stations manually
5
Adjust volume
5
5 Other features
6
6 Product information
7
7 Troubleshooting
7
Set alarm time 6
Set sleep timer 6
Adjust display brightness 6
2 EN
1 Important
Safety
•
Read these instructions.
•
Heed all warnings.
•
Follow all instructions.
•
Do not block any ventilation openings. Install
in accordance with the manufacturer’s
instructions.
•
Do not install near any heat sources such as
radiators, heat registers, stoves, or other
apparatus (including ampliers) that produce
heat.
•
Protect the power cord from being walked on
or pinched, particularly at plugs, convenience
receptacles, and the point where they exit
from the clock radio.
Only use attachments/accessories specied
by the manufacturer.
•
•
Unplug this apparatus during lightning storms
or when unused for long periods of time.
Refer all servicing to qualied service
personnel. Servicing is required when the
apparatus has been damaged in any way,
such as power-supply cord or plug is
damaged, liquid has been spilled or objects
have fallen into the apparatus, the apparatus
has been exposed to rain or moisture, does
not operate normally, or has been dropped.
•
•
Battery usage CAUTION - To prevent battery
leakage which may result in bodily injury,
property damage, or damage to the clock
radio:
•
Install all batteries correctly, + and - as
marked on the unit.
•
Remove batteries when the unit is not used
for a long time.
•
The battery shall not be exposed to
excessive heat such as sunshine, re or the
like.
•
•
This clock radio shall not be exposed to
dripping or splashing.
•
Do not place any sources of danger on the
clock radio (e.g. liquid lled objects, lighted
candles).
Notice
Any changes or modications made to this
device that are not expressly approved by
MMD Hong Kong Holding Limited may void
the user’s authority to operate the product.
Hereby, TP Vision Europe B.V. declares that
this product is in compliance with the
essential requirements and other relevant
provisions of Directive 2014/53/EU. You can
nd the Declaration of Conformity on
www.philips.com/support.
This product complies with the radio
interference requirements of the
European Community.
This product is designed and
manufactured with high-quality
materials and components,
which can be recycled and reused.
This symbol means the product must
not be discarded as household waste
and should be delivered to an
appropriate collection facility for
recycling. Follow local rules and never
dispose of the product and rechargeable
batteries with normal household waste.
Correct disposal of old products and
rechargeable batteries helps prevent
negative consequences for the
environment and human health.
This symbol means that the product
contains batteries covered by European
Directive 2013/56/EU which cannot
be disposed of with normal household
waste. Inform yourself about the the
local separate collection system for
electrical and electronic collection
system for electrical and electronic
products and batteries. Follow local
rules and never dispose of the product
and batteries with normal household
waste. Correct disposal of old products
and batteries helps prevent negative
consequences for the environment and
human health.
Where the plug of the Direct Plug-in Adapter
is used as the disconnect device, the
disconnect device shall remain readily
operable.
3
EN
2
Your clock radio
Congratulations on your purchase, and welcome
to Philips! To fully benet from the support that
Philips oers, register your product at
www.philips.com/support.
Introduction
With this clock radio, you can
•
•
listen to FM radio
What's in the box
Check and identify the contents of your package:
• Main unit
• Power adaptor
• Quick start guide
• Safey sheet
Warranty
•
Overview of the clock radio
1 6
7
2
3
4
5
1
6
2
3
4
7
set two alarms to ring at dierent times.
• Turn on or switch to standby.
PRESET / SET TIME
• Store radio stations in memory.
• Select a preset radio station.
• Set time.
HR / MIN / TUN
•
Tune to FM radio stations.•
Set hour and minute.
SNOOZE / BRIGHTNESS
• Snooze alarm.
• Adjust display brightness.
SLEEP / SCAN
•
Scan and store radio stations automatically.
•
Set the sleep timer.
5
Display panel
• Display current status.
AL1 / AL2 / VOL
•
Set alarm.
• Adjust volume.
4 EN
Caution
•
Risk of product damage! Make sure that the power
voltage corresponds to the voltage printed on the
back or underside of the clock radio.
• Risk of electrical shock! When you unplug the power
cord, always pull the plug from the socket. Never pull
the cord.
Note
•
3
Get started
Always follow the instructions in this chapter in
The batteries can only back up clock and alarm
settings.
Connect the power adaptor to the wall outlet.
sequence.
Install batteries
Connect power
Caution
• Risk of explosion! Keep the batteries away from heat,
sunshine or re. Never discard batteries in re.
• Batteries contain chemical substances, so they should
be disposed of properly.
• Do not mix battery types: e.g. alkaline with carbon
zinc. Only use batteries of the same type for the set.
The type plate is located at the bottom of the clock
radio.
Insert 2 AAA batteries (not provided) with
correct polarity (+/-) as illustrated.
Set time
Note
• You can only set time in standby mode.
1
In standby mode, press and hold SET TIME
for 2 seconds.
2
Press
HR
to set hour and
MIN
to set
minute, then press to conrm.
SET TIME
The time is set.
5
EN
4
Listen to FM radio
Note
• Keep the clock radio away from other electronic
devices to avoid radio interference.
• For better reception, fully extend and adjust the
position of the FM antenna.
Tune to FM radio stations
1 Press to turn on the clock radio.
2 Press and hold
TUN
for 2 seconds.
The clock radio tunes to a station with
strong reception automatically.
3 Repeat Step 2 to tune to more radio stations.
To tune to a station manually:
Press TUN repeatedly to select a frequency.
Note
• The tuning grid of the clock radio is 50KHz, the radio
frequency on the display panel will increase 0.1MHz
by pressing
TUN
twice.
Tip
• To remove a pre-stored station, store another station
in its place.
Select a preset radio
station
In FM tuner mode, press PRESET
repeatedly to
select a preset number.
Adjust volume
While listening, press
VOL
to adjust volume.
Store FM radio stations
automatically
Store FM radio stations
manually
In FM tuner mode, press and hold SCAN for
more than 2 seconds.
The unit stores all the available FM radio
stations automatically and broadcasts the
rst station.
Note
• You can store a maximum of 20 FM radio stations.
1 In FM tuner mode，tune to an FM radio station.
2 Press and hold PRESET for 2 seconds to
activate programming mode.
The preset number begins to blink.
3 Press
TUN
TUN
repeatedly to select a number.
4 Press again to conrm.PRESET
5 Repeat steps 1 to 4 to store more FM radio
stations.
Option A:
1 In FM tuner mode, press PRESET.
2 Press to select a preset radio station.
Option B:
6 EN
5
Other features
Set alarm time
Set alarm
Note
• You can only set the alarm in standby mode.
• Make sure that you have set the clock correctly.
1
In standby mode, press and hold
AL1
or
AL2 for 2 seconds to set alarm time.
2
Press HR to set hour and MIN to set
to conrm.minute, then press
AL1 or AL2
Tip
• The unit exits alarm setting mode when being idle for
10 seconds.
Select alarm source
You can select FM radio or buzzer as the alarm
source by pressing
AL1 or AL2 in standby
mode.
The corresponding alarm icon lights up.
Activate/deactivate alarm timer
Press AL1 or AL2 repeatedly to activate or
deactivate the alarm timer.
If the alarm timer is activated, the alarm
indicator turns on.
If the alarm timer is deactivated, the alarm
indicator turns o.
The alarm repeats ringing for the next day.
To stop the alarm, press the coresponding
AL1 or AL2.
Snooze the alarm
When the alarm sounds, press SNOOZE .
The alarm snoozes and repeats ringing 9
minutes later.
Set sleep timer
This clock radio can switch to standby mode
automatically after a preset period.
• Press SLEEP repeatedly to select a period
(in minutes).
The clock radio switches to standby mode
automatically after the preset period.
To deactivate the sleep timer:
• Press SLEEP repeatedly until [
OFF
] (o)
appears.
Adjust display brightness
Press
BRIGHTNESS
repeatedly to select
dierent brightness levels:
•
High
•
Medium
•
Low
7
EN
6
Product
information
Note
• Product information is subject to change without prior
notice.
Rated Output Power 400mW RMS
Tuner (FM)
Amplier
Tuning Range 87.5-108 MHz
Tuning Grid 50 KHz
Sensitivity
- Mono, 26 dB S/N Ratio
<22 dBf
Total Harmonic Distortion <3%
Signal to Noise Ratio >50 dBA
General information
AC Power (power
adaptor)
Brand: Philips
Model: AS030-
Input: 100-240V~
50/60 Hz; 0.15A
Output: 5V
0.6A
Operation Power
Consumption
<3 W
Standby Power
Consumption
<1 W
Dimensions
(W x H x D)
186 x 96 x 65 mm
Weight
(Main unit)
296 g
7
Troubleshooting
Warning
•
Never remove the casing of the product.
To keep the warranty valid, never try to repair
the device yourself. If you encounter problems
when using this device, check the following
points before requesting service. If the problem
remains unsolved, go to the Philips webpage
www.philips.com/support. When you contact
Philips, make sure that the device is nearby
and the model number and serial number are
available.
No power
• Make sure that the AC power plug of the unit
is connected properly.
• Make sure that there is power at the AC outlet.
No sound
• Adjust the volume.
No response from the unit
• Disconnect and reconnect the AC power plug,
then turn on the unit again.
Poor radio reception
• Keep the clock radio away from other
electronic devices to avoid radio interference.
• Fully extend and adjust the position of the
antenna.
Alarm does not work
• Set the clock/alarm correctly.
Clock/alarm setting erased
• Power has been interrupted or the power
plug has been disconnected.
• Reset the clock/alarm.
• Replace the backup batteries.
050-EE060
TAR3306_12_UM_V1.0
Philips and the Philips Shield Emblem are registered trademarks of Koninklijke Philips N.V. and are
used under license. This product has been manufactured by and is sold under the responsibility of
MMD Hong Kong Holding Limited or one of its aliates, and MMD Hong Kong Holding Limited is
the warrantor in relation to this product.
2021 © MMD Hong Kong Holding Limited. All rights reserved. Specications are subject to change
without notice.
