Loading ...
Loading ...
Loading ...
36 - INSTALLATION 91477A862/A
adhesive seal provided along the entire outer
edge of the hob before assembly.
1. Refer to the dimensions in the figure, bearing
in mind that all the sides of the internal seal
must be flush with the hole.
2. Use light pressure to make the seal stick to
the edge around the hole cut in the worktop.
3. Carefully trim the surplus away from edge
(C) beyond the seal.
Mounting
Over built-in oven unit
The clearance between the hob and the kitchen
units or other built-in appliances must be enough
to ensure sufficient ventilation and air discharge.
If installed above an oven, a space must be left
between the bottom of the hob and the top of
the appliance installed below.
On neutral compartment
If there are other pieces of furniture under the
hob, a double-layer wooden base must be
installed at least 20 mm from the bottom of the
hob to avoid any accidental contact. It must
only be possible to remove the double-layer
base using suitable equipment.
Fixing to the built-in cabinet
In order to ensure fixing to the built-in cabinet
and optimum centring, the supplied fixing
brackets must be screwed into the holes in the
bottom casing.
Screw the fixing brackets into the dedicated
holes to properly fasten the hob to the built-in
Do not use silicone to secure the hob.
This would make it impossible to remove
the hob without damaging it.
1 Opens on bottom
2 Opens on bottom and back
1 Opens on bottom
2 Opens on rear
A min. 10 mm - max. 50 mm
B max. 50 mm
C max. 50 mm
Failure to install the double-layer
wooden base exposes the user to
possible accidental contact with sharp
or hot parts.
Loading ...