Loading ...
Loading ...
Loading ...
Changing Cooktop and
Oven Lights (somemode s)
Thermostat J
Screw--€_
h
FUuorescent
Light
©
GUass
Frame
Be sure the oven is unplugged and all parts are COOL before
replacing the oven light, Wear a leather-faced glove for protection against possible
broken glass.
To Change the Cooktop Light (some models)
Usethe rocker switch located on the top left side of the control panel to turn the
cooktop light on or off.
1. Turn power off at the main source or unplug the range.
2. Removecontrolbuttons.
3. Remove screws from backguard frame trim, two from each side, and lift off.
Remove tile glass panel.
4. Remove bulb by sliding your fingers over the bulb at each end and rotating tile
top of the bulb 1/4tu rn away from you. Replacethe bulb with one of the same
length and wattage.
5. A defective starter can be removed byturning it counter<lockwise 1/4 turn.
6. Replace the glass panel and frame trim on backguard.
7. Replace screws and control buttons.
To Change the Oven Light
Usetile rocker switch located on the top left sideof tile control panel to turn the oven
light on or off.
1. Turn electrical power off at tile main source or unplug the oven.
2. Presswire holder to one side to release the glass shield.
3. Replace bulb with a new 40 watt appliance bulb.
4. Replace glass shield in socket and snap wire holder into place.
5. Turn power back on again at the main source (or plug the oven back in).
6. The clock will then need to be reset. To reset, see Setting the Clock and
Minute Timer in this Owner's Guide.
Adjusting Oven
Forinstructions on how to adjust the oven temperature refer to the Electronic Oven
Control Guide.
17
Loading ...
Loading ...
Loading ...