Loading ...
Loading ...
Loading ...
Genera[ Cleaning
(continued)
When lowering the top,
grasp the sides with fingertips only. Be
careful notto pinch fingers. Also, DO NOT
drop or bend the rangetop when raisingor
lowering. This could damage tile surface.
Hold cooktop flat to remove
_ Support
:¢_ _'J¢ Rod
DO NOTturn the burners
on when the cooktop israisedfor cleaning.
Besurethat thetop iscompletely lowered
and securely in place before turning on
the burners.
To Raise and Lower the Top for Cleaning
1. Remove burner grates and spillover bowls. Set aside.
2. Grasp the front of the cooktop and then lift.
3. Lift the top high enough to fully raisetile support rods. The Lift-up rods will
support the top in its raised position.
4. Clean underneath using hot, soapy water and a clean cloth; then, dry.
5. Lower tile top gently after lowering tile support rod.
To Remove and Replace Burners for Cleaning
Your model will have one of the two burners types shown below. Follow tile
instructions that correspond with the burners on your range.
Figure 1 Figure 2
To Remove Burners (Figure !)
1. Remove shipping screws with a Phillips@ Head screwdriver. Seeillustration for
screw locations.
2. Tiltthe burner atthe end closesttothe support bar until the Iocator tab isreleased
(front burners tilt right, rear burnerstilt left). Move ittoward the back of the range.
This will separate it from the gas valve at the front of the range.
To Remove Burners (Figure 2)
1. Remove shipping screws with a Phillips@ Head screwdriver. Seeillustration for
screw locations.
2. Lift burner pair straight up and out of range.
To RepJace Burners (Figure !)
1. Slide the burner tube over the gasvalve at the front of the range (front burners
fit over tile right valve, rear burners fit over tile left valve on each side of tile
range).
2. Tilt burner sothatthe locating tabwill slideintothe slot on the support bar. Make
sure burners are properly seated on support bar and are level.
3. Replace shipping screws if desired.
Use the finger openings along the
outside edgesof the ovenbottom to raise
and lower the oven bottom.
To Replace Burners (Figure 2)
1. Placeburner pair over mounting bracket. Make sure burners are positioned over
gas valves and are properly positioned and level.
2. Replace shipping screws if desired.
To Remove and Replace Oven Bottom
To Remove the Oven Bottom:
Using the finger openings on each sideof tile oven bottom, pull out and lift up the
oven bottom.
To Replace the Oven Bottom:
1. Graspthe oven bottom and position the front tabs in place in the slots atthe rear
of tile oven.
2. Lower tile front of the oven bottom and slide into place.
15
Loading ...
Loading ...
Loading ...