Loading ...
Loading ...
Loading ...
22
OPERATION USING THE REMOTE CONTROL
• Aim the remote control at the receiver (A11) on the air
conditioner. The maximum distance between the remote
control and the appliance is 5 meters (with no obstacles
between the remote and the receiver).
• The remote control should be handled with extreme care,
without dropping it or exposing it to direct sunlight and
keeping it away from heat sources.
DESCRIPTION OF THE REMOTE CONTROL FIG. D
D1) "ON/STAND-BY" button
D2) Temperature increase/decrease/programmed operation
button
D3) "MODE" button
D4) Fan speed selection button
D5) REAL FEEL selection button
D6) “MAX COOLING” button
D7) °C/°F selection button
D8) TIMER button
INSERTING OR REPLACING BATTERIES
• Remove the cover on the back of the remote
• Insert two LR03 "AAA" 1.5 V batteries in the proper position
(see the indications inside the battery compartment). If the
batteries are low, replace them with the same type.
• Replace the cover.
When replacing or disposing of the remote control, the
batteries must be removed and disposed of according
to current legislation as they are damaging to the envi-
ronment.Do not mix alkaline batteries, standard (zinc-
carbon) batteries or rechargeable (nickel cadmium) bat-
teries.Do not throw the batteries in the re as they could
explode or release hazardous liquids.
TURNING THE APPLIANCE ON AND OFF
• Insert the plug in the socket.
• Press the (D1) button on the remote control (when the
air conditioner is turned on, the last function set before it
was shut down will start).
• To turn the appliance o, press the (D1) button on the
remote control then pull the plug.
NOTE: Never turn o the air conditioner by only pulling the plug.
Press the key and wait a few minutes before pulling the
plug. In this manner, the appliance can perform the operat-
ing status checks.
SELECTING THE OPERATING MODES
The commands available on the remote control correspond to
those on the appliance control panel (C).
Therefore, refer to the instructions in the previous chapters.
The D7 button, on the other hand, allows the temperature scale
to be easily changed from °C to °F and vice versa.
MAX COOLING function
This function consists in the selection of the Cooling mode with
the minimum selectable temperature and the maximum fan
speed.
This function is available only from remote control.
Once activated the Max Cooling function, next pressing of this
key will make the unit restore the previous operating mode and
settings.
D
max 5 m
D1
D4
D2
D8
D6
D5
D3
D7
Loading ...
Loading ...
Loading ...