Loading ...
Loading ...
Loading ...
size being used, see chapter describing the installation to wire feed roll)
.
Pull out the welding wire
○
3 from the welding wire spool carefully; To prevent the
spool from unwinding, maintain tension on the wire until after Step 5.
Cut off the starting end of the welding wire from the wire spool and straighten the
lead section of wire from the spool approximately 4” (100mm) long.
Thread the welding wire through and into the hole
○
4 of the inlet guide tube,
threading it over.
the wire drive roll
○
5 and into the hole
○
6 of the outlet guide tube on the gun side.
Push the wire into the tailpiece of the gun approximately 6 inches.
Place the idle roll arm back to the operating position
○
2 and reset the spring
loaded pressure arm
○
1 of the wire feeder.
SHIELDING GAS INSTALLATION
Compressed gas cylinder containing mixed gas of, 75% Argon and 25% CO2 should
be used when using the MIG (GMAW - GAS Metal Arc Welding). The flow regulator
and supply hose is included with your welder. The compressed gas can be obtained
from your local welding supplier.
Fix the compressed gas cylinder with a chain, or other method to the wall or other
securing devices, to prevent the cylinder of falling.
Figure D-3
Loading ...
Loading ...
Loading ...