Loading ...
Loading ...
Loading ...
APPENDIX
Symptom Checklist
The Jet Bot does not detect the
Boundary Marker and crosses
the boundary.
• Make sure the Boundary Markers are attached as (
)
shape at 15 cm before the locations where the Jet Bot
should not cross.
The Jet Bot suddenly cleans
diagonally.
• Check if the Clean Station is installed along the grain of
wooden oors or tiles.
• The Jet Bot may clean in a diagonal direction if it is
moving to another area using the shortest route. It
may also move at a diagonal if it did not make contact
with an obstacle at a right angle, if it was charged in
a skewed direction at the Clean Station, or If the oor
material is wooden or tile.
Jet Bot does not clean some
places.
• Check whether the Clean Station is installed in a narrow
passage or near a room door and move it to another
place.
– If the Clean Station is installed in a narrow passage
or near a room door, the Jet Bot cannot pass through
the passage or the door.
• Check whether the places the Jet Bot does not clean are
set as No-go Zones.
The Jet Bot cannot nd a room.
• If the Jet Bot does not start cleaning from the Clean
Station, or if the Clean Station is reinstalled to a new
position of 45 degree or 1 m or more from the previous
installed place, the Jet Bot cleans all areas, which is not
based on the created map.
– Start cleaning from the Clean Station.
– When the Jet Bot creates a map and the Jet Bot
starts cleaning, make sure the Jet Bot starts
operating parallel to the wall.
– Remove obstacles within 0.5 m of the left and right
side and 1 m of the front side of the Clean Station.
The map which the Jet Bot has
created is different from the
saved map and the map is also
drawn askew.
English
43
2023-07-13 오전 2:39:51
Loading ...
Loading ...
Loading ...