Loading ...
Loading ...
Loading ...
7
Model LSS020-1
MAINTENANCE / CLEANING / STORAGE
MAINTENANCE:
CAUTION: Blades can cause injury. Do not press
the safety lock of the shear during maintenance
work.
Note: To ensure long and reliable service, regularly
carry out the following maintenance:
Check for obvious defects such as a damaged
or loose blade, housing, or components.
If the tool should stop working properly, repair
should be carried out by a qualified individual,
using identical replacement parts.
CAUTION: Never clean the trimming shears in
water (especially running water), as there is a risk
of personal injury and damage to the shears.
To obtain good cutting results, always make sure
the blades are sharp, and clean them from time to
time with a soft dry cloth.
For easier operation and longer blade life, use light
machine oil to lubricate the trimming and grass
shear blades before and after each use.
Check the condition of the cutting edges of the
blades, and always immediately remove notches
and burrs caused by stones, etc.
There are no parts inside the equipment which
require additional maintenance.
CLEANING / STORAGE
Danger! Remove the rechargeable battery before
cleaning!
To clean the tool, make sure the battery is
detached from the unit.
Clean the exterior of the tool thoroughly
using a soft brush and cloth. Do not use water,
solvents, or polishes.
Remove all debris from the tool.
After cleaning, cover the blades with the
guards provided.
Fully recharge the battery before storing.
If the tool is to be stored for an extended period
of time or during winter storage, charge the
battery at least once every there months to
protect it from damage.
Store the tool in a dry secure place out of reach
of children.
Do not place any other objects on top of the
tool.
The ideal storage temperature is between 5
and 30 °C. Store the tool in its original
packaging.
Do not store the tool in places with static
electricity.
Troubleshooting
Problem
- Unit does not run
Possible Cause
- Battery not making contact
- Lock off is not fully activated
- Battery not installed properly
- Battery not charged
Possible Solution
- Check battery is fully inserted
- Check that lock off is fully activated before moving trigger
- Check that battery is securely connected to the blower
- Check battery charging requirements
- Battery will not charge
- Battery not inserted into charger
- Charger not plugged in
- Surrounding air temperature too hot
or too cold
- Insert battery into charger until red LED appears
- Plug charger into a working outlet
- Check current at receptacle by plugging in a lamp or
other appliance
- Check to see if receptacle is connected to a light switch
which turns power off when you turn out the lights
- Move charger and tool to a surrounding air temperature
of above 39 degree F (4 degree C) or below 104 degree
F (40 degree C)
Loading ...
Loading ...
Loading ...