Loading ...
Loading ...
Loading ...
Mounting System
Read completely before starting
NOTE: Pay close attention to the order of mounting assembly parts, as they have
been correctly assembled by the factory.
A.
Disassemble the mounting assembly, as it has been shipped, by turning the
sink flange assembly until the projections align with the notches in the lower
mount ring and allow you to pull the sink flange up and out of the remaining
lower mount assembly. Note, the sequence of these parts as they are stacked
to identify each part. Unscrew the 3 mounting screws until the mouting ring
can be removed to the top of the back up flange. Remove the snap ring with a
screwdriver.
B. Keep these assembled parts together and set aside. Before you connect the
disposer to the mount assembly under the sink. Make sure the lower mounting is
in place and the Hush Cushion is engaged properly to the top of the hopper.
C. Be sure your sink is clean. Pack the underside rim of the sink flange with
plumber's putty. Position the sink flange so it is centered and readable as you
look into your sink. Push the sink opening to make a good seal. DO NOT move
or rotate the sink flange once seated or the seal may be broken.
D. Take the remaining portion of the mount assembly, as it was set aside and make
sure that the rubber gasket is on top of the protector ring. From under the sink,
while holding the sink flange firmly with one hand, line up the notches in the
mount ring with the projections of the sink flange. Slide the mount assembly up
onto the sink flange. Slide the mount assembly up onto the sink flange, ps the
projections.
E. Tighten the 3 mounting screws evenly with a screwdriver (see E). DO NOT
OVERTIGTEN! Trim off excess putty.
i;,_ IIZIIII_ _ _i_ .... __ j_
M_unt _em_
Loading ...
Loading ...
Loading ...