Loading ...
Loading ...
Loading ...
Tips for Successful Operation
1. Be sure disposer is empty before using your dishwasher so it may drain properly.
2. You may want to leave the stopper in the drain when not in use to prevent utensils
and foreign objects from falling into the disposer.
3. Your disposer is ruggedly built to give you many years of trouble free service. It
will handle all normal food wastes, but it will NOT grind or dispose of such items
as plastic, tin cans, bottle caps, glass china, leather, cloth, rubber, string, clam and
oyster shells, aluminum foil or feathers.
Troubleshoofincj
Beforeseekingrepair or replacement, we recommend that you review the
followlng:
Loud Noises: (Other than those during
grinding of small bones and fruit pits)..
These are ususally caused by accidental
entry of a spoon, bottle cap or other
foreign object. To correct this, turn off
electrical switch and water. After disposer
has stopped, remove splash guard,
remove object with long handled tongs
and replace splash guard.
ifTurntable Does Not Rotate Freely:
Turn off disposer, then check for any
foreign object lodged between the
turntable and grind ring. Dislodge object
by rotating table with a wooden broom
handle and remove object (see 8B). If no
foreign object is present, there may be
internal problems.
Unit Does Not Start: Unplug power cord
or turn either the wall switch or breaker
box switch to "OFF" position, depending
on your model and wiring configuration.
Remove stopper and/or splash guard.
Check to see if turntable will rotate
freely using a wooden broom handle. If
turntable rotates freely, replace splash
guard and check reset button to see if
it has been tripped. Re=set button is red
and located opposite discharge elbow,
near the bottom (see A). Push botton in
until it clicks and remains depressed.
If re-set button has been tripped, check
for a short or broken wire connecting to
disposer. Check electrical power switch,
fuse box or circuit breaker. If wiring and
electrical components are intact, the unit
may have internal problems that require
service or replacement.
Splash Guard not used on Top Control/
Batch Feed units.
Leaks: If the unit leaks at the top, it may
be due to:
1. Improper seating of sink flange
(gasket centering, putty or tightening).
2. Support ring not tightened properly.
3. Defective or improperly installed
cushion mount.
If unit leaks at the waste elbow, leak may
be due to improper tighteing of elbow
flange screws.
Call our toll free Help Line with any questions:
1-800-4-MY-HOME ®
12
Loading ...
Loading ...