Loading ...
Loading ...
Loading ...
– 13 –
9.1 SET-UP
Put the plug into the outlet.
The current temp. and setting temp. both are
displayed during operaton.
In order to be operated, the setting temperature
should be higher than current temperature.
Power On
Important!
For rst use you may need to bleed the fuel pump
lines – this is a simple operation and should only
be required for the initial start or when the machine
has not been used for some time – please see
section 9.3 below.
9.2 SELECT TEMPERATURE OR TIME
CONTROL MODE – FIG. 2
Time control lamp displays when selected.
Every 30min. Operation and 30Min Pause
The repitition time can be set from 5 min. to 25
min. (Only every 5 minutes.)
Repetition time 15 means, every 15min. Operaton
and 15min. Pause
Every 1 min. is shortened as time goes on
Time is shortened every 1 min. when the set time
is 10 min. (10, 9, 8…….1)
Time is shortened every 1 min. when the set time
is 20 min. (20, 19, 18…….1)
Temperature control lamp displays when
selected.
You can set the desired temperature between
‘0~40°C’ by pressing ‘+/-’ button.
When the setting temp. is higher than current
temp. it starts operation, and the setting temp. is
less than current temp. the operation is stop
FIG. 2
9. OPERATING THE HEATER
Loading ...
Loading ...
Loading ...