Loading ...
Loading ...
Loading ...
– 12 –
8. FUELLING
8.1 FUELLING STEP – FIG. 1
Open the fuel inlet cap for the fuel tank.
Carefully put in the fuel, trying not to spill the fuel.
- At this time, ll until the fuel gauge reaches ‘F’.
Tightly close the fuel cap.
Check if fuel has leaked around fuel tank or each
part of the heater. If it has leaked, clean it.
Warning!
During production and assembly some production
substance will be on the heater tubes – these will
simply & harmlessly burn-off during the rst 1-2
hours of use. After this period of use the heater
should not emit unusual smells during use.
Only refuel on at & level ground.
Never refuel the heater when it is operation.
The heater must be switched off & cooled
BEFORE any attempt is made to re-fuel it.
Do not over-fuel the heater, only use enough fuel
to bring the fuel gauge up to the full mark. If you
do spill fuel you MUST ensure that it is fully
cleaned off of the heater and the surrounding
area before use.
Do not use “old” or “second-hand” fuel or any fuel
other than clean, fresh, new Disel or Kerosene.
Using any other type of fuel will invalidate the
warranty and could cause explosion or re.
Do not put low-quality fuel. Always use high-quality
and clean fuel. It may cause breakdown.
FIG. 1
Loading ...
Loading ...
Loading ...