Loading ...
Loading ...
Loading ...
– 11 –
EN
Important: Before using this product, read and
understand all the safety instructions listed in this
manual.
7.1 Preparing the Air Supply for Use with
All Tools
The maximum operating pressure of these air tools is:
• Paint spray gun: 3.5bar (50psi)
• Cleaning gun: 8.0bar (115psi)
• Air gun: 8.0bar (115psi)
• 8.0bar (115psi)
The compressed air system must be controlled by a
combination pressure regulator and moisture lter; this
will ensure a constant supply of dry air at all times,
provided it is properly maintained.
Important: Always check the machine operating
pressure before use.
Water in the compressor tank may cause considerable
corrosion to air tools; the compressor should be drained
daily to avoid excessive water in the air supply. Dirty or
wet air can signicantly shorten the lifespan of the
product.
When using an air tool with a hose over 25ft long,
increasing the bore of the hose to the next largest
available size is recommended (i.e. increase 3/8" to 1/2").
This will ensure adequate pressure and volume of air to
power the tool.
Important: The tyre inator ONLY should be used with a
lubricator also installed in the air line.
CAUTION! DO NOT lubricate the air line when
using the paint spray gun, cleaning gun, or air
gun. For these tools, ensure that any oil device
has been removed and any residual oil purged
from the system before connecting the spray
gun.
7. Preparation Instructions
1 Fig.
Do not install quick
coupling here
To your
air tool
Nipple
Nipple
Oiler
Whip hose Regulator* Air supply
Drain dailyAir line hose
Quick coupler
Water separation
Loading ...
Loading ...
Loading ...