Snow Joe 24V-SS13-TV1 OPERATOR’S MANUAL

Loading ...

8. Install the replacement auger by following the above steps

in reverse order (Fig. 18).

Replacing the Belt

mWARNING! Make sure to turn o the unit and remove

the battery before performing any maintenance task on your

cordless snow shovel.

1. Disassemble the left side cover by removing the

ve (5) screws that hold it in place (Fig. 11).

2. To remove the old belt from the drive wheel, use one hand

to slowly turn the auger while use the other hand to lift the

belt (Fig. 19).

3. Replace a new belt in place. Place the left side cover back

into position and refasten the ve (5) screws.

Replacing the Scraper Bar

mWARNING! Make sure to turn o the unit and remove

the battery before performing any maintenance task on your

cordless snow shovel.

1. Turn the snow shovel over. Using a drill, remove the

four (4) screws that secure the scraper bar to the base of

the unit (Fig. 20).

2. Remove the old scraper bar (Fig. 21).

3. Install the new scraper bar and fasten it securely to the

housing with the four (4) screws (Fig. 22).

Lubricating the Cordless Snow Shovel

This cordless snow shovel does not need lubrication. All

bearings are lubricated at the factory for the life of the product.

Auger

Fig. 17

Fig. 18

Fig. 19

Auger

Drive

wheel

Belt

Fig. 20

Remove

the screws

Fig. 21

Scraper bar

Fig. 22

Fix with

the screws

Loading ...

Snow Joe 24V-SS13-TV1 24-Volt IONMAX Cordless Snow Shovel Bundle W/ 4.0-Ah Battery, Charger, Cover, Ice Dozer and Extended Warranty