Loading ...
Loading ...
Loading ...
11
Routine Maintenance
D
*
Clean every 2 weeks and replace every 6-12 months
D1-1—Main Brush Cover
D1-2—Latches
D1-3—Main Brush
D1-4—Main Brush Caps
D1-5—Main Brush Bearing
D1-6—Turn over the robot and press the
latches to remove the main brush cover.
D1-7—Pull out the main brush and remove
the main brush bearing. Rotate the
main brush caps in the indicated
unlock direction to remove the caps,
and remove any entangled hair or
dirt at both ends of the main brush.
D1-8—Reinstall the main brush.
D1-9—Reinstall the main brush cover. Make
sure that the four teeth are fully
seated in the slot, and then press on
the main brush cover to lock it.
D1
Main Brush
Notes:
•
Main brush should be wiped down with wet cloth and
left to dry away from direct sunlight.
•
Do not use corrosive cleaning uids or disinfectants
to clean the main brush.
D2
Side Brush
*
Clean monthly and replace every 3-6 months
Unscrew the side brush screw. Remove and
clean the side brush. Reinstall the brush
and tighten the screw.
D5
Dustbin
D5-1—Open the top cover of the robot and
press the dustbin latch to take out
the dustbin.
*
Clean as required
To prevent blockage, only use clean water without
any cleaning liquid.
Note:
D5-2—Open the washable lter and empty
the dustbin.
D5-3—Fill the dustbin with clean water and
reinstall the washable lter. Gently
shake the dustbin, and then pour out
the dirty water.
D3-1—Use a tool, such as a small
screwdriver, to pry out the axle and
take out the wheel.
The omnidirectional wheel bracket cannot be removed.Note:
D3
Omnidirectional Wheel
*
Clean as required
D3-2—Rinse the wheel and the axle with
water to remove any hair and dirt.
Dry and reattach the wheel, pressing
it rmly in place.
Clean the main wheel with a soft, dry cloth.
D4
Main Wheel
*
Clean monthly
D5-4—Leave the dustbin and the washable
lter to dry.
D6
Washable Filter
D6-1—Remove the lter.
D6-2—Rinse the lter repeatedly and tap it
to remove as much dirt as possible.
D6-3—Allow 24 hours for the lter to dry
thoroughly and reinstall it.
*
Clean every two weeks and replace the lter every 6-12 months
Do not touch the surface of the lter with your
hands, brush, or hard objects to avoid potential damage.
Note:
D7
Mop Cloths
D7-1—Remove the mop cloth from the mop
cloth mount. Clean the mop cloth
and air-dry it.
D7-2—Stick the mop cloth on the mount in
position and rmly.
*
Clean as required and replace every 1-3 months
A dirty mop cloth will aect the cleaning performance.
Clean it before use.
Note:
D8
Robot Sensors
Use a soft, dry cloth to wipe and clean all
sensors, including:
D8-1—Dock Locator
D8-2—Reactive Tech Obstacle Avoidance
Sensor
D8-3—Wall Sensor
D8-4—Mop Wash Sensor
D8-5—The Carpet Sensor
D8-6—Four Cli Sensors
*
Clean monthly
Loading ...
Loading ...
Loading ...