Loading ...
Loading ...
Loading ...
Screw with
Special Fastener
Round
Terminal
Wire
Terminal
Board
Fig. 2.16
Page 24
mrcool.com
Unit Installation
Connecting the Power Cord & Thermostat Wires
For solid wires (Refer to Fig. 2.15 A):
1. Use wire cutters to cut off the wire end and then peel away about 1 in (25 mm) of the insulation layer.
2. Use a screwdriver to unscrew the terminal screw on the terminal board.
3. Use nippers to bend the solid wire into a ring that fits the terminal screw.
4
. Form a proper ring and attach to the terminal board. Use a screwdriver to tighten the terminal screw.
For braided/strand wires (Refer to Fig. 2.15 B & Fig. 2.16):
1. Use wire cutters to cut off the wire end and then peel away about 3/8 in (10 mm) of the insulation layer.
2. Use a screwdriver to unscrew the terminal screw on the terminal board.
3. Use a round terminal fastener or clamp to secure the round terminal firmly on the peeled wire end.
4
. Locate the round terminal conduit. Use a screwdriver to replace it and tighten the terminal screw (as
shown in Fig. 2.16).
Fig. 2.15
For all terminal wiring (Refer to Fig. 2.18 & 2.19 (2-3 ton unit) or Fig. 2.20 & 2.21 (4-5 ton unit) on
the next page):
5.
Lead the connection wire and power cord through the insulation tube. Then secure
the wires with wire clamps (as shown in Fig. 2.17).
Fig. 2.17
Cord Clamp
Insulation Tube
1 in (25 mm)
3/8 in (10 mm)
Electrical Connection
Loading ...
Loading ...
Loading ...