Loading ...
Loading ...
Loading ...
PAC
®
| Ph. 866-931-8021 | [email protected]
©2016 Pacic Accessory Corporation
www.pac-audio.com
Rev. 090916
Page 4
Pacific Accessory Corporation
Radio Replacement & Steering Wheel Control Interface
for 2014 - 2016 Mercedes Sprinter Vehicles
Equipped with a Factory Radio
RP4.2-MB11
Testing and Verication
1. Turn the key to the ignition position. The LED on the interface will turn on & the +12v accessory wire will turn on.
2. Turn on the radio and check balance and fade.
3. Verify that all SWCs are functioning properly. The LED will ash whenever a SWC button is pressed, even if a function is not
assigned to the button.
4. Verify that all data driven navigation outputs are functioning properly.
5. When using the VS41 to add left, right, front and rear cameras, be sure to trigger them with either the turn signals or the
supplied switch and ensure proper operation.
6. The LED and radio will turn off when the ignition is turned off.
Steering Wheel Controls (cont.)
Optional SWC Programming Procedure
1. Turn the key to the ignition position.
2. Put the Driver Information Center (DIC) in the vehicle’s instrument cluster into the Audio or Telephone mode using the Page
Up or Page Down buttons on the steering wheel. Failure to do this will not allow the Arrow Up and Arrow Down buttons to be
programmed.
3. Press and release programming button on the side of the interface. The Status LED will turn green.
4. Within 7 seconds, press the button that is to be learned on the steering wheel. The LED will turn red when the button is pressed.
At this point you have two options:
A. For short press functionality: Release the button within 1.5 seconds. The LED will turn back on.
B. For long press functionality: Hold the button until the LED starts blinking. Release the button and the LED will
go back to solid green.
5. If you need to program more buttons, repeat step 3 for each additional audio function on the steering wheel.
6. If you come across a function in the chart that your steering wheel does not have, or you do not want to program, press and
release the program button on the side of the interface to skip that function.
7. Once programming is completed, wait seven seconds. The LED will ash three times indicating end of programming.
8. Test the interface for proper functionality. Whenever a SWC button is pressed the LED on the interface should blink. If any
function does not work, repeat the programming steps.
Alpine JVC Kenwood Clarion
Other
Pioneer Sony Fusion
1 Volume + Volume + Volume + Volume + Volume + Volume + Volume + Volume +
2 Volume - Volume - Volume - Volume - Volume - Volume - Volume - Volume -
3 Mute Mute Mute Mute Mute Mute Mute Mute
4 Preset + Source Source Source Preset + Preset + Preset + Source
5 Preset - Track + Play Search + Preset - Preset - Preset - Track +
6 Source Track - Track + Search - Source Source Source Track -
7 Track + Band / Disc + Track - Band Track + Track + Track + Audio
8 Track - Preset / Disc - Disc / FM + Send / End Track - Track - Track - Power
9 Power Select Disc / AM - Send Band Band Band
10 Enter / Play Attenuation Answer End
Answer
Phone Menu
Reject Call / Source
(Bluetooth
equipped radios
only)
11 Band / Program Phone Receive Voice Dial
End
Answer Call Answer / End Call
12 Receive Phone Reject On Hook
PTT
End Call
13 End Voice Dial Off Hook VR
14 VR Power
Mute (Multimedia
units only)
15 Preset +
- Advent, Boyo, Dual, Lightning Audio, Jensen, Rockford Fosgate & Visteon
- Jensen & Advent ONLY
Optional Programming Order