Loading ...
Loading ...
Loading ...
TROUBLESHOOTING - See appropriate section in manual unless directed
to an authorized Service Center,
PROBLEM CAUSE
Loss of power 1o Rear of lawn mower
housingor cuttingblade
dragging in heavy grass_
2. Cutting too much grass°
3, Dirty air filter,
4. Buildupof grass, leaves,
and trash under mower,
5, Toomuch oil in engine°
6. Walking speed too fast-
Poor cut- I. Worn, bent or looseblade,
uneven
2, Wheel heights uneven°
3,, Buildup of grass, leaves
and trash under mower.
......i ........................
Excessive 1, Worn, bent or loose blade
vibration
2_ Bent engine crankshaft.,
Starter rope 14 Engine flywhee! brake is on
hard to pull whencontrol bar is released°
2, Bent engine crankshaft.
3,, Blade adapter broken_
4, Blade dragging in grass,
Grass catcher 1. Cutting height too Iow_
not filling 2, Lift on blade worn off,,
(If so equipped) 3o Catcher not venting airL
Hard to push 1,, Grass istoo high or wheel
height is too low,,
2o Rear of lawn mower
housing or cutting blade
dragging in grass,,
3_ Grass catcher 1oofull,
4o
1, Raise cutting height°
2_ Raise cutting height,
3., Clean/replace air filter°
4o Clean underside of mower
housing_
5o Check oi! level.,
6. Cut at slower walking speed°
1_ Replace blade.Tighten
blade bolt.
2., Set all wheels at same
height.
3. Clean underside of
mower housing.
1. Replace blade, Tighten
blade bolt,,
2_ Contact a qualified service
center,
1o Depress control bar to
upper handle before
pulling starter rope,
2_ Contact a qualified service
center.
3,, Replace blade adapter.
4., Move lawn mower to cut
grass or to hard surlace
1o Raise cutting height°
2. Replace blade.
3. Clean grass catcher,,
1L, Raise cutting height.
2,, Raise rear of lawn mower
housing one (1) setting
higher,
3. Empty grass catcher,.
Handle height position not
fight for you,
4,. Adjust handle height to suit.,