Loading ...
Loading ...
Loading ...
11
8. Turn your water output device to the “on” position and adjust to the desired water flow.
9. There will be a series of audible clicks and the burner will ignite. Please take note the water heater
must not be exposed to flammable vapors or liquids during lighting. Should the burner not ignite
after 5 seconds, shut off and go to the “Troubleshooting” section.
10. Upon completion of use or storage, open the drain valve (ribbed cylindrical stem next to the
water inlet valve) to ensure draining of water.
11. Please turn off the gas supply when not in use.
Before Operate The Drain Plug, Must be
1. Ensure that the water heater is disconnected from the water supply (turn off cold water inlet
switch).
2. Turn the shower switch to “ON”.
3. Ensure that the shower hose is disconnected from the water heater.
To drain the residual water totally,
please keep the water heater in vertical
statue when draining water.
Drain Plug
Water Temperature Adjusting
The temperature of the outgoing water is dependent on the temperature of the incoming water
balanced with the amount of heat applied. Use extreme caution in setting the outlet water
temperature.
Please Protect Your Water Heater From Freeze Damage!
WARNING: If the outside temperature is around or below freezing (32 °F/0°F), ensure that the
drain plug is opened and water drained from the portable tankless water heater after each
use to avoid internal damage to the heat exchanger. You will also need to unhook the
outgoing water line to ensure that any water in the heat exchanger is drained. Failure to
properly drain your portable tankless water heater will cause water damage which may or
may not be repairable.
1. The water flow knob in position max and the gas knob in position
min is the lowest temperature setting available.
2. To raise the water temperature, adjust the gas knob up (toward
max);
3. After step 2, if you still need water temperature higher, adjust
the flow rate knob down(toward min) until you have the desired
temperature.
4. The middle knob is for adjusting the amount of propane burned per unit time.
When the initial water is too hot in summer, you could turn it to the position.
One burner work to lower the temperature and save propane. When the initial
water is too cold in winter, you could turn it to the position so all of the
burners will work to raise the temperature.
Loading ...
Loading ...
Loading ...