Loading ...
Loading ...
Loading ...
10
USE AND STARTING
Note:
This appliance shall only be connected to a 20lb (Size 1: φ12 5/16″ *H17 5/16″;
Size 2: φ11 13/16″ *H17 7/16″;) cylinder with a POL cylinder valve certified to
CAN/CSA-B339. The LP-gas cylinder(s) must be constructed and marked in accordance with the
specifications for Cylinders, Spheres, and Tubes for the Transportation of Dangerous Goods,
CSA B339.
Please inspect the hose before each use of the appliance. If it is evident there is excessive
abrasion or wear, or the hose is cut, it must be replaced prior to the appliance being put into
operation. The replacement hose assembly shall be that specified by the manufacturer.
Check: Turn on the gas shut-off valve to the water heater. Use a soapy water solution to test for
leaks at all the connections and fittings. If bubbles are seen, it indicates a gas leak that must be
corrected and contact a qualified service technician.
The gas must be turned off at the LP gas supply cylinder when the water heater is not in use.
When the LP-gas supply cylinder is not disconnected from the water heater, the water heater and
cylinder must be stored outdoors, in a well ventilated space, out of the reach of children, and
must not be stored in a building, garage or any other enclosed area.
Storage of the water heater indoors is permissible only if the cylinder is disconnected and
removed from the water heater.
Cylinders must be stored outdoors, in a well ventilated space, out of the reach of children, and
must not be stored in a building, garage or any other enclosed area.
Do not store a spare LP gas cylinder under or near this appliance. Never fill the cylinder beyond
80 percent full. If not followed exactly, it may lead to a fire.
Check around the area for flammables, especially gasoline, or other vapors which may ignite. The
exhaust and top of the portable tankless water heater will get HOT! Make sure there are no foreign
objects around the portable tankless water heater or have fallen into the top.
WARNING: The water heater must not be exposed to flammable vapors or liquids during lighting.
1. Turn on incoming water supply. Ensure that you have abundant water pressure between 2.2-116
PSI/15-800 kPa for ideal operation.
2. Turn your water output device to its “off ” position.
3. Turn the gas valve on the cylinder all the way open.
4. IF THE SMELL OF GAS IS DETECTED, TURN OFF THE GAS VALVE IMMEDIATELY!!
5. Set the burner power switch knob to position. (In winter this knob can be switched to ）
6. Set the water control knob to Maximum.
7. Set the gas control knob on to Minimum.
●
●
●
●
●
●
●
●
Burner power switch knob
( position is full power)
Gas flow adjustment knob
( position is lowest
temperature Water temperature display
Water flow adjustment
knob ( position is
maximum flow)
Loading ...
Loading ...
Loading ...