Loading ...
Loading ...
Loading ...
Refrigerator
Overlay
(59.40 cm)
Recessed Inset Installation Dimensions
1. Measure the distance from point A (as shown) to back wall.
2. Rout the front edge of the support board or attach a %"
(9.5 mm) board to hold the panel in the cabinet side trim.
Side Trim
3/8"
(9.7 mm)
1/16"
(1.5 ram)
3/16"
"<--- (4.5 mm)
(3.2 ram) __
Inset Installation Dimensions
1. Measure the distance from point A (as shown) to the back
wall. Add %2" (0.8 mm) to this measurement to allow the side
panel to fit into the trim.
2. If the panel is more than %" (9.5 mm) thick, rout the front
edge to allow the side panel to fit into the trim.
S
INSTALLATION
REQUIREMENTS
IMPORTANT:
• Installer: Leave Installation Instructions with the homeowner.
• Homeowner: Keep Installation Instructions for future
reference. Save these Installation Instructions for the local
electrical inspector's use.
TOOLS NEEDED:
Gather the required tools and parts before starting installation.
Read and follow the instructions provided with any tools listed
here.
• Hand drill or electric drill • Torx°_T27 screwdriver
(properly grounded)
• Drill bits • rl/s2" nut driver
• Two adjustable wrenches • %" and 1/_,,open-end
wrenches
• Phillips screwdriver • s/=,, Allen wrench
• Small level • s/16"socket wrench
• Appliance dolly • Tape measure
PARTS NEEDED:
• Six #8 x 3" (7.6 cm) wood screws (longer screws may be needed)
• One or two 2" x 4" x 32" (5 cm x 10 cm x 81 cm) wood board(s)
• Order factory panels, make custom panels or consult a
qualified cabinetmaker or carpenter to make the panels.
Classic Series: Order factory panels, make custom panels, or
consult a qualified cabinetmaker or carpenter to make the
panels. See "Design Specifications" for more information.
Overlay Series: Make custom panels, or consult a qualified
cabinetmaker or carpenter to make the panels. See "Design
Specifications" for more information.
Pro Line®, Complete and Architect ®Series are shipped
complete.
• If you are connecting the water line directly to copper tubing
and not to a shutoff valve, you need a ferrule, a union, and a
1/4"(6.35 mm) compression fitting.
1-CeTORXis a registered trademark of Textron Innovations Inc.
15
Loading ...
Loading ...
Loading ...