Loading ...
Loading ...
Loading ...
Installation Instructions
ADDING ELBOW FOR EXHAUST
THROUGH BOTTOM OF CABINET
• Insert the elbow through tile rear opening and connect it to
the dryer internal duct.
• Apply duct tape on the joint between tile dryer internal
duct and elbow, as shown on page 6.
CAUTION:
Internal duct joints must be secured with tape,
otherwise they may separate and cause a
safety hazard.
ADDING COVER PLATE TO REAR
OF CABINET (SIDES AND BOTTOM
EXHAUST)
Connect standard metal elbows and ducts to complete tile
exhaust system. Cover back opening with a plate (Kit
WE 1M454) available from your local service provider.
Place dryer in final location.
- NEVER LEAVE THE BACK I
OPENING WITHOUT THE PLATL (KitWE1M454) I
IT0qCHANGING DIRECTION OF
DOOR OPENING
1. ()pen tile door and remove tile filler plugs opposite tile
hinges. _¥ith tile door completely open, remove the
bottom screws from each hinge on tile dryer face. Insert
these screws about halfway into tile TOP holes, for each
hinge on tile opposite side (where you removed tile filler
plugs). Apply firm pressure to get tile screw started.
2. Loosen tile top screws from each hinge on tile dryer face
halfway. _¥ith one hand holding the top of the door and
the other hand holding the bottom, remove the door
from the dryer by lifting it UP and OUT.
3. Rotate the door 180°. Insert the door on the opposite side
of the opening by moving the door IN and DOWN
until the top hinge and the bottom hinge are resting on
the top screws inserted in step 1.
4. Remove the remaining screws from the side of the
opening from which the door was removed. With these
screws secure each hinge at the bottom. Tighten the two
top screws on each hinge. Reinsert the plastic plugs on
the side from which the door was removed.
LOOSENTHETOP
REMOVETHE SCREWSFROM
BOTTOMSCREW EACHHINGEON
FROMEACHHINGE THEDRYERFACE
ONTHEDRYER HALFWAY.
MOVETHEDOORINAND
DOWNUNTILTHETOPHINGE
ANDTHEBOTTOMHINGEARE
RESTINGONTHETOPSCREWS
INSERTEDINSTEP1,
SECUREEACHHINGE
ATTHEBOTTOMAND
TIGHTENTHETWOTOP
SCREWSOFEACHHINGE.
TO REGISTER YOUR DRYER
CALL TOLL-FREE
1-888-269-1192
Promptregistrationconfirmsyour rightto protectionunderthe
termsof yourwarranty.
www.GEAppliances.com (US)
For Questions on Installation, Call: 1-800-626-2003 (US)
500A187PO_7 2 Ill ()N Ihlb # 31 15175
7
[] SERVICING
_k WARNING- LABEL ALL WIRES
PRIOR TO DISCONNECTING WHEN
SERVICING CONTROLS. WIRING
ERRORS CAN CAUSE IMPROPER AND
DANGEROUS OPERATION AFTER
SERVICING/IN STALLATION.
For servicing phone numbers for replacement parts, and
other information, refer to Owner's Manual or visit our
Web site.
Loading ...