Loading ...
Loading ...
Loading ...
Installation Instructions
[] DRYER EXHAUST TO RIGHT, LEFT
OR BOTTOM CABINET
iF=
I/A,WARNING- BEFORE PERFORMING
THIS EXHAUST INSTALLATION, BE SURE
TO DISCONNECT THE DRYER FROM ITS
ELECTRICAL SUPPLY. PROTECT YOUR
HANDS AND ARMS FROM SHARP EDGES
WHEN WORKING INSIDE THE CABINET.
BE SURE TO WEAR GLOVES
REMOVE
SCREW
ANDSAVE.
REMOVE
DESIRED
KNOCKOUT
(ONEONLY),
Detach and remove the bottom, right or left side knockout
as desired. Remove the screw inside the dryer exhaust duct
and save. Pull the duct out of the dryer.
FIXINGHOLE
{
B A
Cut the duct as shown and keep portion A.
TAB LOCATION
BENDTAB
UP45o
Through the rear opening, locate the tab in the middle of
the appliance base. Lift the tab to about 45° using a fiat
blade screwdriver.
6
ADDING NEW DUCT
FIXING
HOLE
_ PORTION"A"
RIGHTOR
LEFTSIDE
EXHAUST
Reconnect tile cut portion (A) of tile duct to tile blower
housing. Make sure that the shortened duct is aligned with
the tab in tile base. Use the screw saved previously to secure
tile duct in place through the tab on tile appliance base.
ADDING ELBOW AND DUCT FOR
EXHAUST TO LEFT OR RIGHT
SIDE OF CABINET
• Preassemble 4" elbow with 4" duct. _¥rap duct tape
around joint.
Insert duct assembly, elbow first, through tile side opening
and connect tile elbow to the dryer internal duct.
CAUTION: Be sure not to pull or damage the
electrical wires inside the dryer
when inserting the duct.
EXHAUSTCAN
BEADDEDTO
LEFTORRIGHTSIDE
\
DUCT
TAPE
J
Apply duct tape as shown on the joint between the dryer
internal duct and the elbow.
DUCT
CAUTION:
Internal duct joints must be
secured with tape, otherwise
they may separate and cause
a safety hazard.
Loading ...
Loading ...