Loading ...
Loading ...
Loading ...
Clean the base filter
Clean the heat exchanger
28
WARNING
•
•
Do not operate your dryer without the lint filter in place.
Do not use a damage or broken lint filter. This may reduce performance
and/or cause fire.
WARNING
Do not touch the heat exchanger with your hand, which may cause an
injury.
•
•
•
•
•
•
•
Open the cover.
Unlock three locking levers and grasp the
filter handle.
Remove the base filter and clean it. If there
is too much lint on the filter, clean it in water.
Dry the filter thoroughly before installing it
back.
Clean the rubber sealing, both at the filter
and handle.
Re-insert the filter.
Lock three locking levers and make sure
that the levers are in lock position.
Close the cover until there is a click sound.
•
•
•
•
The fluff accumulated on the filter will block the air circulation. Not
cleaning the filter regularly will increase drying time and energy
consumption.
Disconnect the power cord before cleaning!
Do not operate the dryer without the filter!
Clean the base filter after each fifth cycle to prevent fluff accumulation
inside the dryer.
•
•
As necessary, approx. once every 2 months,
remove the fluff from the heat exchanger using
a vacuum cleaner with a dusting brush attached.
Clean the heat exchanger without applying any
pressure. Otherwise the heat exchanger could
be damaged. The dryer will not dry if the
cooling fins are damaged or bent.
NOTE:
Filter Base
Requirements
Installation
Instructions
Dryer Use
Dryer Care
Troublesho
o
ting
Safety and
Precautions
Installation
Loading ...
Loading ...
Loading ...