Loading ...
Loading ...
Loading ...
- 19 -
AIR FILTER (Fig28):
After every 100 hours of running or every month, the air filter should be removed,
examined for deterioration, and deaned. Clean the air filter thoroughly using an
environmentally friendly water-based degreasing agent Allow to dry thoroughly；
then replace the air filter. Only run the engine with the air filter fitted.
STORAGE:
If the engine is not to be used or is to be stored for more than one month the
following storage procedure should be carried out
1.Drain all the fuel from the fuel tank and the carburetor ensure that all the fuel has
been removed.
2.Remove the spark plug and pour approximately one tablespoon full of clean
engine oil into the spark plug hole.
3.With the ignition turned OFF gently pull on the recoil starter cord several times.
4.Re-fit the spark plug and continue to pull the recoil starter cord until the piston is
on the compression stroke (when resistance is felt) then stop pulling.
5.Store the pressure washer in a dry well ventilated place under a cover to prevent
any dust or debris from accumulating on the pressure washer.
WINTER AND LONG TERM STORAGE:
If the pressure washer is not to be used for more than 3 months or if there is a
danger of ice or frost during winter months the pump unit will require protection to
prevent seizing and damage caused by freezing.
MAINTENANCE
EXHAUST CONTROL SYSTEM
With the engine running, carbon monoxide, nitrogen oxide and hydrocarbon are
produced, and in certain conditions nitrogen oxide and hydrocarbon will react
together to make smoke while carbon monoxide is toxic, so exhaust control is very
important. The manufacturer decreases exhaust emissions by introducing
poor-fuel carburetors and other devices to solve the problem. To keep the exhaust
Loading ...
Loading ...
Loading ...