Loading ...
Loading ...
Loading ...
CLEANING THE RANGE, Continued
Aluminum Foil in Oven and Broiler
Aluminum foil when used improperly is a cause of many range fires. Make certain
heating elements aren't covered or come in contact with aluminum foil.
Never cover a rack completely. A piece of foil slightly larger than the utensil can be placed
on the rack beneath the utensil.
USER SERVICING
• Do not repair or replace arty part of the appliance unless specifically recommended in
this manual. All other servicing should he relerred to a qualified technician.
• Disconnect the range from electrical supply beli_re attempting to service or move it.
• If you pull the range out from the wall lk_rany reason, make sure the rear leg is returned
to its position in the anti-tip bracket when you push the range back.
Repair Parts
When repair parts are needed, contact the dealer fi'om whom the range was purchased. In
case your range was purchased from some source other than an appliance dealer you may
prefer to contact the manufacturer of the range at the address shown in this manual.
MOISTURE
During irutial heat-up of your range, the heat mixing with the cooler air in the oven cavity
may produce fogging of the door glass or a collection of water on the door. To prevent
this, open the oven door lk_rthe first l_:w seconds of initial oven heat-up. This will allow
moist air within the oven to escape without the lk_rmiug of visible moisture on the range.
The amount of moisture will depend upon tire humidity of the air arrd water content of tire
l_od being cooked. Fogging and even dripping water will usually occur in geographic
locations of high humidity.
OVEN VENT
The oven vent tube has been eliminated. By omitting the vent tube, a greater amount of
moisture is retained; therelkwe, baked loods with greater appeal are created. The lkx)d itself
retains more of its natural juices arrd has less tendency to dry out. The flavor is better.
ALIGNMENTS AND ADJUSTMENTS
Oven Door Spring Adjustments
Tire oven door springs are properly adjusted heli_re leaving tire l_tctory. The springs shouhl
he adjusted to allow the door to remain open when pulled 90 degrees li)rward and yet pull
the door tight against the oven front fi'ame when closed. If adjustments should become
necessary, remove the storage drawer and grasp spring with fingers, and pull downward.
To give more tension, push toward rear of range and attach in first slot. To make spring
adjustment on ranges without storage drawer, remove l_tlse panel and follow the same
procedure.
21
Loading ...
Loading ...
Loading ...