Loading ...
Loading ...
Loading ...
Back-UPS BE425M/425M-LM, BN450M/450M-CA
9
This Safety Guide contains important instructions that should be followed during
installation and maintenance of the APC by Schneider Electric equipment and batteries.
It is intended for APC by Schneider Electric customers who setup, install, relocate, or
maintain APC by Schneider Electric equipment.
Read, understand, and follow ALL safety instructions contained in this manual.
Failure to follow safety instructions and warnings could result in equipment
damage, serious injury, or death.
Changes and modifications to this unit not expressly approved by APC by
Schneider Electric could void the warranty.
WARNING! Handling Safety
WARNING! Deenergize Safety
The UPS contains internal batteries and may present a shock hazard even when
disconnected from the branch circuit (mains). Before installing or servicing the
equipment verify the following:
• Mains circuit breaker is in the OFF position.
• Internal UPS batteries are removed.
• XLBP battery modules are disconnected.
WARNING! Electrical Safety
• Adhere to all national and local electrical codes.
• Do not work alone under hazardous conditions.
• This unit contains no user serviceable parts. Some UPS models have user
replaceable internal batteries.
• To avoid personal injury due to energy hazard, remove wrist watches and jewelry
such as rings when replacing the batteries.
• Use tools with insulated handles.
• High current through conductive materials could cause severe burns.
• Do not handle any metallic connector before the power has been disconnected.
• Check that the power cord(s), plug(s), and receptacles are in good condition.
• If ground cannot be verified, disconnect the equipment from the utility power
outlet before installing or connecting to other equipment. Reconnect the power
cord only after all connections are made.
• The protective earth conductor for the UPS carries the leakage current from the
load devices (computer equipment). An insulated ground conductor must be
installed as part of the branch circuit that supplies the UPS. The conductor must
have the same size and insulation material as the grounded and ungrounded
branch circuit supply conductors. The conductor will be green, with or without a
yellow stripe.
<18 kg
<40 lb
18-32 kg
40-70 lb
32-55 kg
70-120 lb
>55 kg
>120 lb
Safety Information - SAVE THIS GUIDE
Loading ...
Loading ...
Loading ...