Loading ...
Loading ...
Loading ...
Back-UPS BE425M/425M-LM, BN450M/450M-CA
11
THIS POLICY IS NOT A WARRANTY. REFER TO THE LIMITED WARRANTY FOR INFORMATION CONCERNING
THE WARRANTY FOR YOUR APC PRODUCT. THE LIMITATIONS AND CONDITIONS IN THIS POLICY DO NOT
AFFECT THE TERMS OF THE WARRANTY.
“Equipment Protection Policy”
’In the 50 US States, Canada, and Bermuda for 120 Volt Products’
If your electronic equipment is damaged by power line transients on an AC power line (120 volt), while directly and
properly connected to a standard Schneider Electric IT Corporation (SEIT), 120 volt product covered by the Equipment
Protection Policy (“connected equipment”), and if all of the remaining conditions specified below are met, SEIT will, at
sole option of SEIT, during the period specified below, replace the SEITproduct and either (a) pay for the repair of the
equipment or (b) reimburse you for the fair market value, as determined by the then current price list of the Orion Blue
Book (or equivalent), of the connected equipment, in an amount not to exceed the dollar limits stated below, if SEIT
determines that the damage was caused by the failure of the SEIT product to protect against power line transients,
(telephone line, network, or CATV transients, if applicable). Power line transients that APC products have been designed
to protect against, as recognized by industry standards, include spikes and surges on AC power lines (not designed as
protection against swells as defined by IEEE 1100-1992). Protection from telephone line transients applies only to SEIT
products which offer telephone line protection, and in cases in which such protection is available, telephone service
equipment must include a properly installed and operating “primary protection” device at the service entrance (such
devices are normally added during telephone installation) in order to be covered for telephone line transients. Protection
of CATV (Cable Television) connected equipment from transients applies only to SEIT products which offer such
protection, and in such cases, the CATV service must be properly grounded according to the codes set forth in the
National Electric Code (NEC) in order to be covered for CATV transients.Protection from network line transients applies
only to SEIT products which offer network line protection.
This SEIT policy applies to SEIT ProtectNet products if the power line to the equipment it is protecting is using only SEIT
products, with an applicable Equipment Protection Policy, to protect against power line transients. The coverage of the
ProtectNet product will then be covered under the SEIT power protection product Equipment Protection Policy. This
policy does not apply to SEIT ProtectNet products if used individually without SEIT AC power protection products.
SEIT reserves the right to determine whether the damage to the connected equipment is due to SEIT product failure by
requesting that damaged equipment be sent to SEIT for inspection. This policy is in excess of, and applies only to the
extent necessary beyond any coverage for the connected equipment provided by other sources, including, but not limited
to, any manufacturer’s warranty, and any extended warranty coverage.
Equipment Protection Policy Dollar Limits
For customers that meet the qualifications and conditions set forth in this policy, SEIT will provide reimbursement (cost of
repair or fair market value) up to the dollar amount listed at http://www.apcc.com/support/service/equipment_protection_
policy.cfm. You can also call at 1-800-800-4APC or fax us at 1-401-788-2743 to request this information.
Eligibility for coverage under the Equipment Protection Policy:
1. You must register the product by returning to SEIT the warranty card provided with the product within 10 days of
purchase. All information must be filled in, and you should retain a copy for your records. The warranty card must
clearly identify the types of electronic equipment that will be plugged into the APC product for which protection under
this policy is claimed. All connected equipment must be UL or CSA approved.
2. The SEIT product must be plugged into properly wired and grounded outlets; no extension cords, adapters, other
ground wires, or electrical connections may be used, with the sole exception of other standard SEIT 120 volt products.
The installation must not include power protection products made by any manufacturer other than SEIT. The
installation must comply with all applicable electrical and safety codes set forth pursuant to the National Electrical
Code (NEC).
3. Any claim under the Equipment Protection Policy must be made within 10 days of the date of alleged damage to the
connected equipment.
4. The Equipment Protection Policy covers only standard SEIT 120 volt products used in the 50 US states, Canada, and
Bermuda.
What is not covered under the Product Policy:
1. Restoration of lost data and reinstallation of software are not covered.
2. This policy does not cover damage from a cause other than AC power line transients, except for damage due to
telephone line, network or CATV transients, which is covered only if the SEIT product offers such protection.
In addition, the following are expressly excluded from coverage:
3. Damage caused by failure to provide a suitable installation environment for the product (including, but not limited to,
lack of a good electrical ground).
4. Damage caused by the use of the SEIT product for purposes other than those for which it was designed.
5. Damage caused by accidents, or disasters such as fire, flood, or wind.
6. Damage caused by abuse, misuse, alteration, modification, or negligence.
7. This policy is null and void if, in view of SEIT, the SEIT product has been tampered with or altered in any way.
8. EXCEPT AS EXPRESSLY PROVIDED IN THIS POLICY, IN NO CASE SHALL APC BE LIABLE UNDER THE TERMS
OF THIS POLICY FOR ANY DAMAGES WHATSOEVER, INCLUDING, BUT NOT LIMITED TO, DIRECT, INDIRECT,
SPECIAL, INCIDENTAL, CONSEQUENTIAL, OR MULTIPLE DAMAGES ARISING OUT OF THE USE OF THE APC
PRODUCT OR DAMAGE TO THE CONNECTED EQUIPMENT, REGARDLESS OF THE LEGAL THEORY ON
WHICH SUCH CLAIM IS BASED, EVEN IF ADVISED OF THE POSSIBILITY OF SUCH DAMAGE. SUCH DAMAGES
INCLUDE, BUT ARE NOT LIMITED TO, LOSS OF PROFITS, LOSS OF SAVINGS OR REVENUE, LOSS OF USE
Loading ...