Loading ...
Loading ...
Loading ...
English
English 19
Installation requirements
Electrical supply and grounding
• AC 120 V / 60 Hz / 15 AMP fuse or circuit breaker is required.
• Use an individual branch circuit specific to the washer.
To ensure proper grounding, the washer comes with a power cord featuring a three-prong grounding plug
for use in a properly installed and grounded outlet.
Check with a qualified electrician or service person if you are not sure about the grounding.
Do not modify the provided plug. If it does not fit the outlet, call a qualified electrician to install a proper
outlet.
WARNING
• Do NOT use an extension cord.
• Use only the power cord that comes with the washer.
• Do NOT connect the ground wire to plastic plumbing, gas lines, or hot water pipes.
• Improperly connected grounding conductors may cause electric shock.
• To prevent unnecessary risk of fire, electrical shock, or personal injury, all wiring and grounding must
be done in accordance with local codes, or in the absence of local codes, in accordance with the National
Electrical Code, ANSI/ NFPA No. 70-Latest Revision (for the U.S.) or the Canadian Electrical Code CSA
C22.1 – Latest Revisions and local codes and ordinances. It is your responsibility to provide adequate
electrical service for your washer.
Water supply
A proper water pressure for this washer is between 20-116 psi (137-800 kPa). Water pressure less than
20 psi (137 kPa) may cause the water valve not to close completely. Or, it may take longer to fill the drum,
causing the washer to turn off. Faucets must be within 4 feet (122 cm) from the rear of the washer so that
the provided inlet hoses reach the washer.
To reduce the risk of leaks:
• Make sure faucets are easily accessible.
• Turn off the taps when the washer is not in use.
• Check for any leaks at the water inlet hose fittings on a regular basis.
CAUTION
Before using the washer for the first time, check all connections at the water valve and taps for any leaks.
Drain
Samsung recommends a standpipe in height of 18 in (46 cm). The drain hose must be connected through the
hose clip to the standpipe, and the standpipe must fully cover the drain hose.
A2-WW6900_WASHER-MD_SimpleUX_03645H-00_EN.indd 19 2022/12/31 11:17:13
Loading ...
Loading ...
Loading ...