Loading ...
Loading ...
Loading ...
not, adjust the camera according to the figure
below.
Pan Position
[0° to 360°]
Bracket Adjusting Screw
Rotation Position
[0° to 360°]
Tilt Position
[0° to 90°]
Figure 2-3 3-Axis Adjustment
2.2 Ceiling/Wall Mounting of Type II Camera
Before you start:
The ceiling mounting and the wall mounting are similar.
Following takes ceiling mounting as an example.
Steps:
1. Paste the drill template (supplied) to the place
where you want to install the camera.
2. Drill the screw holes according to the drill template,
and the cable hole (optional) on the ceiling.
Figure 2-4 Drill Template
Note:
Drill the cable hole in the center of the drill template,
when adopting ceiling outlet to route the cable.
3. Route cables through the cable hole or the side
opening.
4. Attach the camera to the ceiling with supplied
screws.
Figure 2-5 Attach the Camera to the Ceiling
Note:
The supplied screw package contains self-tapping
screws, and expansion bolts.
For cement wall/ceiling, expansion bolts are
required to fix the camera. For wooden
wall/ceiling, self-tapping screws are required.
5. Connect the corresponding power cord, and video
cable.
6. Power on the camera to check whether the image
on the monitor is gotten from the optimum angle. If
not, loosen the trim ring to adjust the angle.
Pan Position
[0° to 360°]
Rotation Position
[0° to 360°]
Tilt Position
[0° to 90°]
Trim Ring
Figure 2-6 3-Axis Adjustment
Loading ...
Loading ...
Loading ...