Loading ...
Loading ...
Loading ...
OPERATION
IMPORTANTSAFETYINSTRUCTIONS
Toreducethe riskof SEVEREINJURYor DEATH:
1. READAND FOLLOWALL WARNINGSAND INSTRUCTIONS.
2. ALWAYS keep remote controls out of reach of children.
NEVERpermit children to operate or play with garagedoor
control push buttons or remote controls.
3. ONLYactivate garagedoor when it can be seen clearly, it is
properly adjusted, and there are no obstructions to door
travel.
4. ALWAYS keep garage door in sight until completely closed.
NO ONESHOULDCROSSTHEPATHOFTHEMOVING
DOOR.
5. NO ONESHOULDGOUNDERA STOPPED,PARTIALLY
OPENEDDOOR.
6. If possible, use emergency release handle to disengage
trolley ONLYwhen garage door is CLOSED.Weakor broken
springs or unbalanced door could result in an open door
falling rapidly and/or unexpectedly, causing SEVEREINJURY
or DEATH.
7. NEVERuse emergency release handle unless garage
doorway is clear of persons and obstructions.
8. NEVERuse handleto pull garagedoor open or closed. If
rope knot becomes untied, you could fall.
9. If one control (force or travel limits) is adjusted, the other
control may also need adjustment.
10. After ANY adjustments are made, the safety reversal system
MUST betested.
11. SSafety reversal system MUST be tested every month.
Garagedoor MUST reverseon contact with 1-1/2" high
(3.8 cm) object (or a 2x4 laid flat) on the floor. Failureto
adjust the garagedoor opener properly may cause SEVERE
INJURYor DEATH.
12. ALWAYS KEEPGARAGEDOORPROPERLYBALANCED
(see page3). An improperly balanced door may NOT
reversewhen required and could result in SEVEREINJURY
or DEATH.
13. ALL repairs to cables, spring assemblies and other
hardware,ALL of which are under EXTREMEtension, MUST
be made by a trained door systems technician.
14. ALWAYS disconnect electric power to garagedoor opener
BEFOREmaking ANY repairs or removing covers.
15SAVETHESEINSTRUCTIONS.
Using Your Garage Door Opener
Your Security.I-®opener and hand-held remote control have been
factory-set to a matching code which changes with each use,
randomly accessing over 100 billion new codes. Your opener will
operate with up to eight Security.I-®remote controls and one
Security.I-® Keyless Entry System. If you purchase a new remote
control, or if you wish to deactivateany remote control, follow the
instructions in the Programming section.
Activateyour openerwithany of the following:
• TheHand-Held Remote Controh Hold the large push button
down until the door starts to move.
• The Wall-Mounted Door Controh Hold the push button or bar
down until the door starts to move.
• TheKeyless Entry (seeAccessories): If provided with your
garagedoor opener, it must be programmed before use.
SeeProgramming.
Whenthe opener is activated (with the safety reversingsensor
correctlyinstalled and aligned)
1. If open, the door will close. If closed, it will open.
2. If closing, the door will reverse.
3. If opening, the door will stop.
4. If the door has been stopped in a partially open position, it will
close.
5. If obstructed while closing, the door will reverse. If the
obstruction interrupts the sensor beam,the opener lights will
blink for five seconds.
6. If obstructed while opening, the door will stop.
7. If fully open, the door will not close when the beam is broken.
The sensor has no effect in the opening cycle.
If the sensor is not installed, or is misaligned, the door won't
close from a hand-held remote control. However,you can close
the door with the Door Control or KeylessEntry, if you activate
them until down travel is complete. If you releasethem too soon,
the door will reverse.
Theopenerlights will turn on under the following conditions:
when the opener is initially plugged in; when power is restored
after interruption; when the opener is activated.
Theywill turn off automatically after 4-1/2 minutes or provide
constant light when the Light feature on the Premium Control
Console Panelis activated. Bulb size is A19. Bulb power is
100 watts maximum.
Security÷ _light feature: Lights will also turn on when someone
walks through the open garagedoor. With a Premium Control
Console, this feature may be turned off as follows: With the
opener lightsoff, press and hold the lightbutton for 10 seconds,
until the lightgoes on, then off again. To restorethis feature, start
with the opener lightson, then press and hold the lightbutton for
10 seconds until the lightgoes off, then on again.
3O
Loading ...
Loading ...
Loading ...