Loading ...
Loading ...
Loading ...
8 9
Installation
Operation
Air Outlet
Power Cord
Hooks
Radiator Grille
Drainage Port
Built-in Handle
Handle
Control Panel
Air Inlet
Universal Castors
Wheel
PARTS OVERVIEW
WARNING:
Do not block the Drain Hose. The end of the Drain Hose should not be higher than the outlet
hole. If the end of the Drain Hose is higher than the outlet hole, water will not drain properly
and could damage the components of the unit.
1. Place the device on its front side.
2. Mount the Handle (2) to the device sides using Screws (3).
The hole sites must be aligned on both sides.
Mounting the Casters
1. Lay down the unit by pulling the Handle backward. This will reveal the appliance's bottom.
2. Fix the two Casters (7) with Screws (8) to the two brackets on the appliance's bottom by using
a screwdriver (we recommend electric). Each Caster. Each Caster should be installed using
four Screws.
Mounting the Wheels
1. Place the device on its front side.
2. Attach an Axle (9) with 2 Screws (10) to the bottom of the device by using a screwdriver
3. Add a Washer (4) onto the Axle.
4. Mount a Wheel (5) in front of the Washer.
5. Use a Locating Pin (6) to secure the Wheel (5) on the Axle.
6. Repeat steps 2 to 5 to install the Axle on the other side.
7. After mounting the Casters and the Wheels, place the device in an upright position.
Install the Drain Hose
Attach the supplied Drain Hose to the Drainage Port on the appliance.
Direct the Hose to the desired area before operating the appliance.
• If the drain area is located above the Dehumidifier, the maximum capacity of the water
pump is 16.4 ft (5 m). If the water is drained downwards, there is no limit for the distance.
Drain Hose
NOTE: READ BEFORE FIRST USE (See page 5) before following these steps.
Loading ...
Loading ...
Loading ...