Loading ...
Loading ...
Loading ...
Kärcher TRS-SSG • Operators • 9.801-330.0-K
17
PRESSURE WASHER
OPERATOR’S MAN U AL
98013300-13
98013300-9
STEP 9: Before installing pressure
nozzle, trigger spray gun to elimi-
nate trapped pressure. Then run
machine, allowing water to flush
through the system until clear.
PRESSURE WASHER OPERATING INSTRUCTIONS
Thermostat
Burner
Switch
STEP 7: Turn the key to the START
position, and hold it there until the
engine starts. If the engine fails to
start within 5 seconds, release the
key, and wait at least 10 seconds
before op er at ing the starter again.
Using the electric starter for more
than 5 seconds at a time will
over heat the starter motor and
can dam age it.
When the engine starts, release the
key, allowing it to return to the ON
position. If the choke knob has been
pulled to the CLOSED position to
start the engine, grad u al ly push it
to the OPEN position as the engine
warms up.
98013300-12
ON
OFF
START
Engine
Switch
98013300-14
Safety
Latch
WARNING! Never replace noz -
zle without engaging the safe ty
latch on the spray gun trig ger.
STEP 8:Turn the burner switch
"ON". Turn thermostat dial to the
desired temperature setting.
98013300-28
Selection of high or low pressure is accompanied by
turn ing the han dle. NOTE: High pressure nozzle must
be in sert ed at end of wand to obtain high pressure. To
apply soap, read detergent instructions.
Variable Pressure
Control Handle
Trigger
Variable Pressure
Wand (VP)
High
Pressure
Nozzle
Brass Soap Nozzle
Loading ...
Loading ...
Loading ...