Loading ...
Loading ...
Loading ...
![](https://files.manualsfile.com/23116642-917258691/bg19.png)
..... iii
SERVICE AN
i1,111,11,1,1ii
"POSITIVE .... NEGATIVE"
(+) (-)
FIG. 32
TO REPLACE HEADLIGHT BULB
• Raise hood,
. Pull bulb holder out of the hole in the backside of the
grill,
• Replace bulb in holder and push bulb holder securely
back into the hole in the backside of the grill
• Close hood_
INTERLOCKS AND RELAYS
Loose or damaged wiring may cause your tractor to run
poorly, stop running, or prevent it from starting.
• Check wiring, See electrical wiring diagram in the
Repair Parts section of this manual,
TO REPLACE FUSE
Replace with 30 amp automotive-type plug-in fuse, The
fuse holder is located behind the dash,,
TO REMOVE HOOD AND GRILL ASSEMBLY
(See Fig. 33)
o Raise hood.
o Unsnap headlight wire connector.
o Stand infront oftractor. Grasp hood at sides, tilttoward
engine and lift off of tractor.
o To replace, reverse above procedure°
HOOD
ENGINE
FIG. 33
TO ADJUST THROTFLE CONTROL CABLE
(See Figs. 34 & 35)
The throttle control has been preset at the factory and
adjustment should not be necessary, Check adjustment as
described below before loosening cable If adjustment is
necessary, proceed as follows:
,,11,1,,11,1111111,i i ................
ADJUSTMENTS
iiiiii1,,111,,,i,ii, , i i .................iiiiiii, ,i,i, i
• With engine not running, move throttle control lever to
fast (,_) position_
o Check that speed control lever isagainst stop screw. If
it is not, loosen casing clamp screw and pull throttle
cable until lever is against screw. Tighten clamp screw
securely.
CASING STOP SCREW SPEED CONTROL
CLAMP LEVER
SCREW
THROTTLE
CABLE
FIG. 34
STOP
SCREW
SPEED
CONTROL
LEVER
FIG, 35
TO ADJUST CARBURETOR (See Fig. 36)
The carburetor has been present at the factory and adjust-
ment should not be necessary_ However, minor adjustment
may be required to compensate for differences in fuel,
temperature, altitude or load. If the carburetor does need
adjustment, proceed as fol{ows:
In general, turning the adjusting needles in (clockwise)
decreases the supply of fuel to the engine giving a leaner
fuel/air mixture. Turning the adjusting needles out (coun-
terclockwise) increases the supply of fuel to the engine
giving a richer fue!/air mixture
IMPORTANT; DAMAGE TO THE NEEDLES AND THE
SEATS IN CARBURETOR MAY RESULT IF SCREW IS
TURNED 1NTOO TIGHT.
PRELIMINARY SETTING -
. Be sure you have a clean air filter, and the throttle
control cable is adjusted properly (see above)°
• With engine off turn idlefuel adjusting needle in (clock-
wise) closing it finger tight and then turn out (counter-
clockwise) 1-1/4 turns.
o Turn main fuel adjusting needle in (clockwise) closing
finger tight and then turn out (counterclockwise) 1 turn°
25
Loading ...
Loading ...
Loading ...