Loading ...
Loading ...
Loading ...
Using the Watch in a Medical
Facility or Aircraft
When you are in a hospital, on an aircraft, or
in any other location where radio signals may
cause problems, you can perform the
procedure below to disconnect the watch from
your phone so they can’t communicate with
each other (Airplane Mode). Use the same
procedure when you want to disable the
Airplane Mode.
1. Enter the Timekeeping Mode.
l
Navigating Between Modes
2. Hold down (B) for at least two seconds.
Release the button when the name of the
currently selected Home City appears on
the display.
Home City
3. Press (C) 15 times.
This displays the Airplane Mode icon.
Airplane Mode icon
4. Press (D) to toggle between the Airplane
Mode settings.
[ON]: Airplane Mode enabled.
[OFF]: Airplane Mode disabled.
5. Press (B) to exit the setting screen.
Using Mobile Link with
a Mobile Phone
While there is a Bluetooth connection
between the watch and phone, the watch time
setting is adjusted automatically. You can also
change the watch’s other settings.
Note
●
This function is available only while
EDIFICE Connected is running on the
phone.
●
This section describes watch and
phone operations.
X
: Watch operation
Y
: Phone operation
Getting Ready
To use your watch in combination with a
phone, you first need to pair them. Perform the
steps below to pair the watch with a phone.
●
A
Install the required app on your
phone.
In Google Play or the App Store, search for the
CASIO “EDIFICE Connected” app and install
it on your phone.
●
B
Configure Bluetooth settings.
Enable the phone’s Bluetooth.
Note
●
For details about setting procedures,
see your phone documentation.
●
C
Pair the watch with a phone.
Before you can use the watch in combination
with a phone, you first need to pair them.
1. Move the phone to be paired with close to
(within one meter of) the watch.
2.
Y
Tap the “EDIFICE Connected” icon.
3.
X
Hold down (D) for at least two seconds.
Release the button when [CNCT]
changes from high speed flashing to slow
flashing.
4.
Y
Perform the operation shown on the
screen of the phone to be paired with.
●
[CNCT] will flash on the watch display
when pairing starts. [OK] will be
displayed when pairing is complete.
Pairing complete.Pairing started.
Note
●
The first time you start up EDIFICE
Connected, a message will appear on
your phone asking if you want to
enable location information
acquisition. Configure settings to allow
background use of location
information.
Operation Guide 5618
6
Loading ...
Loading ...
Loading ...