Loading ...
Loading ...
Loading ...
PRODUCT ASSEMBLY PRODUCT ASSEMBLY
1.Place the radiator body upside-down on a scratch-free location, make sure it is
stable and will not fall.
2.Screw off the wing nuts from the U-shaped bolt provided, attach the U-shaped
bolt to the U-facing flange between first and second fins(near the front cover).
3.To attach the castor mounting plate to the radiator body, you should insert the
threaded ends of the U bolt in the holes on the castor mounting plate.
4.Screw the wing nuts back to the U bolt and fasten the wing nut properly.
Note: do not over tighten, which may cause the damage of radiator flange.
5.Repeat 2, 3, and 4 on the rear of radiator for mounting of the rear Castors.
Note: the rear castors must be mounted between the end two fins.
INSTRUCTIONS FOR USE
1
.Before using the heater make sure that it is on a flat and stable surface.
Damage may occur if it is placed on an incline or decline.
2.Set the power switch to 0 (OFF) position and the thermostat to MIN position
Then insert the plug into a socket-outlet well grounded.
3.Rotate the thermostat knob clockwise to MAX position and rotate the power
switch of the heater as follows: LOW (1power－600 watts); MED (2 power－
900 watts); HIGH (3 power－1500 watts); 0 for power off.
4.When your room reaches the desired temperature, now slowly rotate the
thermostat knob counter clockwise until the clicks sound comes. The thermostat
can now be left at this setting. As soon as the room temperature has dropped below
the set temperature, the unit will switch on automatically until the set temperature
has been reached again. In this way the room temperature remains constant with
the most economical use of electricity.
5.If you want to change the room temperature setting, rotate the thermostat knob
clockwise to raise the temperature, or counter clockwise to lower it.
6.This heater includes an overheat protection system that shuts off the heater when
parts of the heater are getting excessively hot.
7.To completely shut the heater off, turn all the controls to OFF, and remove plug
from the socket-outlet.
06 07
Loading ...
Loading ...
Loading ...