Loading ...
Loading ...
Loading ...
Tighten adjust nut
B to raise mower
Loosen adjust nut
B to lower mower
Loosen jam nut A first
TO REMOVE WHEEL FOR REPAIRS
1. Block up axle securely.
2. Remove axle cover, retaining ring and
washers to allow wheel removal (rear
wheels have a square key - Do not
lose).
3. Repair tire and reassembfe.
NOTE: On rear wheels only: align
grooves in rear wheel hub and axle. Insert
square key,
4. Replace washers and snap retaining
ring securely in axle groove.
5. Replace axle cover.
NOTE: To seal tire punctures and prevent
flat tires due to slow leaks, purchase and
use tire sealant from Sears. Tire sealant
also prevents tire dry rot and corrosion,
Washers
Retaining
Ring
TO CHECK BRAKE
If tractor requires more than five (5) feet to
stop at highest speed in highest gear on a
level, dry concrete or paved surface, then
brake must be serviced.
You may also check brake by:
I, Park tractor on a level, dry concrete or
paved surface, depress brake pedal
all the way down and engage parking
brake.
2. Disengage transmission by placing
freewheel control in 'transmission dis-
engaged" position, Pull freewheel con-
trol out and into the slot and release so
it is held in the disengaged position.
The rear wheels must lock and skid
when you try to manually push the tractor
forward, tf the rear wheels rotate, then the
brake needs to be serviced. Contact a
Sears or other qualified service center,
FRONT WHEEL TOE-IN/CAMBER
Your new tractor front wheel toe-in and
camber is set at the factory and is normal°
The front wheel toe-in and camber are
not adjustable, If damage has occurred to
affect the factory set front wheel toe-in or
camber, contact a Sears or other qualified
service center_
Axle Cover
I
_--xSquare Key (Rear
Wheel Only)
TO REPLACE MOWER DRIVE BELT
MOWER DRIVE BELT REMOVAL
1_ Park tractor on a level surface° Engage
parking brake.
2, Lower attachment lift lever to its lowest
position.
3, Disengage belt tension rod from lock
_jL bracket,
AUTION: Belt tension rod is spring
loaded, Have a firm grip on rod and re-
lease slowly.
4. Remove screws from R,H. and L.H.
mandrel covers and remove covers.
5. Remove any dirt or grass clippings
which may have accumulated around
mandrels and entire upper deck sur-
face,
6. Remove belt from electric clutch pulley,
both mandrel pulleys and all idler pul-
leys.
28
Loading ...
Loading ...
Loading ...