Loading ...
Loading ...
Loading ...
Troubleshooting
ActionError messages
Unblocking the drain pump. See the chapter Care and maintenance
instructions. If the problem persists, contact your nearest Customer
Care Center.
Overfilling waterF10
See "Water remains in the dishwasher above the filters" under
"Problem" in the table below. If the problem persists, contact your
nearest Customer Care Center.
Water outlet faultF11
Check that the water supply valve is on. If the problem persists,
contact your nearest Customer Care Center.
Water inlet faultF12
The water pressure should be 4.2-140 psi.
Turn off the water supply valve and contact your nearest Customer
Care Center.
Inlet valve leakageF40
Turn off the water tap. Unplug the electrical supply and contact
your nearest service center.
Heater fault 1F41
Turn off the water supply valve and contact your nearest Customer
Care Center.
Overfilling waterF54
To avoid water leakage outside the dishwasher, do not unplug
the electrical supply until the water tap on the supply line has been
turned off!
Check that the water supply valve is on. If the problem persists,
contact your nearest Customer Care Center.
Water inlet faultF67
The water pressure should be 4.2-140 psi.
Press any button to clear the error message.
ActionPossible causesProblem
Wait a moment then try again.You have pressed the control
panel too soon after opening the
door.
The control panel does not react
when pressed.
Open the door. The control
panel only reacts to use when
the door is open.
The door is closed.
Clean with a dry or slightly
damp cloth.
Dirt on the control panel.
Check that the baskets are cor-
rectly positioned horizontally.
The baskets are not correctly
positioned.
Cannot close door.
Check that the dishes are not
blocking the baskets from slid-
ing properly into place.
Check the door lock. If it does
not click into place and lock,
open the door.
The door lock does not click in-
to place and lock.
25
Loading ...
Loading ...
Loading ...