Loading ...
Loading ...
Loading ...
9
ENG
Product has been designed to be mounted to worktops procured from market. A safe distance must be left
between the product and kitchen walls or furniture. See the drawing provided on the next page for proper
distances. (values in mm).
• Used surfaces, synthetic laminates and adhesives must be heat resistant. (minimum 100 °C)
• Kitchen cupboards must be level with product and secured.
• If there is a drawer below the oven, a rack must be placed between oven and drawer.
• Do not install the product next to refrigerators or coolers. The heat emitted by the
product increases the energy consumption of cooling devices.
• Do not use door and/or handle to carry or move the product.
Right Place For Installation
Installation And Mounting
Place of use for product must be located before starting installation.
Product mustn't be installed in places which are under the effect of strong air flow.
Carry the product with minimum two people. Do not drag the product so that floor isn't damaged.
Remove all transportation materials inside and outside the product. Remove all materials and documents in the
product.
Installation Under Counter
Cabin must match the dimensions provided in figure 2.
A clearance must be provided at the rear part of the cabin as indicated in the figure so that necessary ventilation
can be achieved.
After mounting, the clearance between lower and upper part of the counter is indicated in figure 5 with "A". It's for
ventilation and shouldn't be covered.
Installation In An Elevated Cabinet
Cabin must match the dimensions provided in figure 4.
The clearances with the dimensions indicated in the figure must be provided at the rear part of cabin, upper and
lower sections so that necessary ventilation can be achieved.
Installation Requirements
Product dimensions are provided in the figure 3.
Furniture surfaces for mounting and mounting materials to be used must have a minimum temperature resistance
of 100 °C.
Mounting cabin must be secured and its floor must be plane for product not to tilt over.
Cabin floor must have a minimum strength that would handle a load of 60 kg.
Placing And Securing The Oven
Place the oven into the cabin with two or more people.
Ensure that oven's frame and front edge of the furniture match uniformly.
Supply cord mustn't be under the oven, squeeze in between oven and furniture or bend.
Fix the oven to the furniture by using the screws provided with the product. Screws must be mounted as shown
in figure 5 by passing them through plastics attached to frame of the product. Screws mustn't be overtightened.
Otherwise, screw sockets might be worn.
Check that oven doesn't move after mounting. If oven isn't mounted in accordance with instructions, there is a risk
of tilt over during operation.
WARNING!
Loading ...
Loading ...
Loading ...