Loading ...
Loading ...
Loading ...
WHAT CAN HAPPEN IF THERE IS A LACK OF MAINTENANCE?
There is friction between the running belt and the running deck when
in use. Any kind of friction creates wear which reduces the life of your
treadmill. By lubricating between the running belt and the running deck
with the included lubricating oil, this friction is reduced, thus increasing the
life of both parts. If the treadmill runs dry, the running deck will get hot,
and the surface of the running deck and the running belt may be damaged
or destroyed. Friction can also lead to a static charge which can discharge
on contact with the frame. This is not only unpleasant but can also destroy
the treadmill’s electronics.
CLEANING & GENERAL MAINTENANCE
• Use a slightly damp cloth to wipe any dirt or moisture from the product
after each use. You may use a small amount of mild soap or detergent,
as needed. Dry the cleaned areas thoroughly.
• Do not use abrasive, corrosive, solvent, or chemical cleaners or harsh
detergents to clean the product.
• Inspect for visible damage before use. Do not use if damaged or
malfunctioning.
• Only use with the original parts and accessories provided by the
manufacturer.
• Never open the motor hood unless instructed to do so by an authorized
service representative. Servicing other than the procedures in this manual
should be performed by an authorized service representative only.
DAMAGE CAUSED BY NEGLECT OR LACK OF MAINTENANCE AND CARE
IS EXCLUDED FROM THE WARRANTY.
Endurance Training Collection 17
MAINTENANCE AND CARE
WARNING: Switch off the power and remove the power cord from the
electrical outlet before performing any care, cleaning, maintenance, repair,
or similar work on your treadmill. Only when all work is fully completed may
the treadmill be reconnected to an electrical outlet and powered on.
BEFORE FIRST USE OR AFTER A LONG BREAK FROM TRAINING
Make sure that there is a continuous film of lubricant on the running deck.
If this is not the case, then use the included bottle of lubricating oil to
apply a lubricant film. See LUBRICATING THE RUNNING BELT on page 18.
MAINTENANCE & CLEANING INTERVALS
WIPE DOWN THE TREADMILL: AFTER EACH USE
Wipe down after every use. Clean only with a damp cloth.
CHECK THE LUBRICATION OF THE RUNNING BELT: ONCE A WEEK
If your regular inspection shows that there is no longer enough lubrication,
lubricate the belt immediately and shorten the inspection interval
accordingly. Please see LUBRICATING THE RUNNING BELT on page 18 for
instructions. If the treadmill has been in storage for a long time, check
whether there is still enough lubricant present.
CHECK THE ALIGNMENT OF THE RUNNING BELT: ONCE A WEEK
The alignment of the running belt must be checked regularly. If you notice
that the belt is running to one side, this must be corrected immediately.
Please see ADJUSTING THE RUNNING BELT on page 20.
WHY IS MAINTENANCE OF MY TREADMILL SO IMPORTANT?
In order to enjoy using your treadmill for many years, it is important to
regularly and consistently do basic maintenance. The maintenance interval
will depend very much on how often you use your treadmill, and therefore
the intervals may need to be shorter than specified.
16 PacerMini User Manual Lifepro
Loading ...
Loading ...
Loading ...