Loading ...
Loading ...
Loading ...
INSTALL MOWER AND DRIVE BELT (See
Figs. 5 and 7)
Be sure tractor is on level surface and mower suspension
arms are raised with attachment liftcontrol. Engage park-
ing brake,,
. Cut and remove ties securing anti-sway bar and belts.
Swing anti-sway bar to left side of mower deck,,
. Slide mower undertractorwith discharge guard to right
side of tractor.
IMPORTANT' CHECK BELT FOR PROPER ROUTING IN
ALL MOWER PULLEY GROOVES, INSTALL BELT iNTO
ELECTRIC CLUTCH PULLEY GROOVEr
BLY
o
o
o
o
o
Place the R.H_ suspension arm on outward pointing
deck pin. If necessary, rock and raise front of mower
to align deck pin with the hole in suspension arm,
Retain with double loop retainer spring with loops down
as shown,,
Connect anti-sway bar to chassis bracket under left
footrest and retain with double !oop retainer spring_
Turn height adjustment knob clockwise to remove
slack from mower suspension,
Raise mower to highest position,,
Assemble gauge wheels (See "TO ADJUST GAUGE
WHEELS" in the Operation section of this manual),,
• Install one front link in top hole of the R.H, front mower
bracket and RoH_front suspension bracket. Retain with
two single loop retainer springs as shown°
• Install secondfront linkin Loll front suspension bracket
only and retain with single loop retainer spring as
shown.
• Turn height adjustment knob counterclockwise until it
stops.,
• Lower mower linkage with attachment lift control.
o Place the LoHosuspension arm on outward pointing
deck pin., If necessary, rock and raise front of mower
to align deck pin with the hole in suspension arm.
Retain with double loop retainer spring with loops down
as shown,,
= Slide left side of mower back and installthe unattached
front link in top hole of the L°H_front mower bracket.
Retain with single loop retainer spring as shown..
CHECK MOWER LEVELNESS
For best cutting results, mower should be propedy leveled,
See "TO LEVEL MOWER HOUSING" in the Service and
Adjustments section of this manual.
CHECK FOR PROPER POSITION OF ALL
BELTS
See the figures that are shown for replacing motion, mower
drive, and mower blade drive belts in the Service and
Adjustments section of this manual, Verify that the belts
are routed correctly_
ELECTRIC
CLUTCH
PULLEY,
FRONT
SUSPENSION
BRACKETS
DOUBLE LOOP
RETAINER SPRING
CHASSIS (outward pointing
BRACKET deck pins)
SUSPENSION
ARMS
FRONT
MOWER
BRACKET
FRONT
LINK
SHOULDER
BOLT
GAUGE
WHEEL
/
318WASHER
USE PLtERSFOR
RETAINER SPRINGS
3_16
CENTER
LOCKNUT
DOUBLE LOOP
RETAINER ANTI-SWAY
SPRING BAR
IDLER /
PULLEY
FIG. 5
SINGLE
LOOP
RETAINER
SPRINGS
DISCHARGE GUARD
9
Loading ...
Loading ...
Loading ...