Loading ...
Loading ...
Loading ...
,ll,i ,lln,ll
PROBLEM
Engine continues to run
when operator leaves seat
with attachment clutch
engaged
Poor cut - uneven
Mower blades will not
rotate
Poor grass discharge
Headlight(s)notworking
(if so equipped)
_=_n_u,t_ i i ll=l,i ,,1,, i
Battery will not charge
Engine "backfires"
when turning engine
"OFF"
TROUBLESHOOTING POINTS
......................... i = i ,= ill i,,l=lH==,,, iHi = illll
CAUSE CORRECTION
1,, Faulty operator-sali_ty presence cont_'ol system,
1, Worn, bent or loose blade.
2, Mower deck not leve_.
3 Buildup of grass, leaves, and trash under mower.
4, Bent blade mandrel,
5. Clogged mower deck vent betas from buildup of
grass, leaves, and trash around mandrels
1,, Obstruction in clutch mechanism
2 Womfdamaged mower drive bell
3, Frozen idler pulley
4, Frozen b_ade mandrel
1, Engine speed too slow.
2. Travel speed too fast..
3. Wet gras&
4_ Mower deck not level
5. Lowtuneven tire air pressure.
6, Worn, bent or toose blade
7, Buildup of grass, leaves and trash under mower,
8. Mower drive belt worn
9. Blades improperly installed
10, improper blades used.
11 Clogged mower deck vent holes from buildup of
grass, leaves, and trash around mandrels
1, Switch is "OFF",
2. Butb(s) burned out
3, Faulty light switch
4. Loose or damaged wiring,,
5, B!own fuse
1 Bad battery ceil(s),
2,. Poor cable connections,
3 Faulty regulator (if so equipped),
4 Faufty alternator.
1. Engine throttle control not set at "SLOW"
position for 30 seconds before slopping engine,
1 Check wiring, switches and connections if not
corrected, contact an authorized service center/
department,
1 Replace blade,, Tighten blade bolt
2, Level mower deck,
3. Clean underside of mower housingĀ°
4 Replace blade mandrel.
5 Clean around mandrels to open vent holes,
1 Remove obstruelion,
2. Replace mowerddva belt
3 Replace idler pulley,
4 Replace blade mandrel
1 Place throttle control in "FAST" position,.
2 Shift to stower speed.
3 Allow grass to dry before mowing
4 Level mower deck,
5o Check tires for proper air pressure,
6 Replace/sharpen blade. Tighten blade bolt
7. Cleanunderslde of mower housing.
8, Replace mower dr_vebelt
9, Reinstall blades sharp edge down.
I0. Replace with blades listed in lhis manual.
11_ clean around mandrels to open vent holes
1 Tum switch "ON",.
2 Replace bulb(s),.
3 CheckJreplace light switch,.
4. Check wiring and connections,
5, Replace fuse,,
1 Replace battery,
2, ChecWclean all connections,.
3 Replace regulator,,
4,. Replace alternator.
1, Move throttle control to "SLOW" position and allow
to idle for 30 seconds before stopping engine
28
Loading ...
Loading ...
Loading ...