Loading ...
Loading ...
Loading ...
o Rinse the battery with plain water and
dry,
o Clean terminals and battery cable ends
with wire brush until bright.
o Coat terminals with grease or petroleum
jelly.
o Reinstall battery (See "CONNECT BAT-
TERY" in the Assembly section of this
manual)°
V-BELTS
Check V-belts for deterioration and wear
after 100 hours of operation and replace if
necessary,, The belts are not adjustable.
Replace belts if they begin to slip from
wear.
TRANSAXLE COOMNG
Keep transaxle free from build-up of dirt
and chaff which can restrict cooling,,
ENGINE
LUBRICATION
Only use high quality detergent oil rated
with API service classification SF, SG or
SH, Select the oil's SAE viscosity grade
according to your expected operating tem-
perature.
SAE VISCOSITY GRADES
_F _o_ o" _- _- _. _- loo"
I {: -3o" _" -1o" o" zo- _- _ 4o-
ITEMPE_RE RANGE,/LNTICiPATED BEFoR_ _ 0iL _GE
NOTE: Although multi-viscosity oils
(5W30, ! 0W30 etco) improve starting in
cold weather, these multi-viscosity oils will
result in increased oil consumption when
used above 32°R Check your engine oil
level more frequently to avoid possible
engine damage from running low on oiL
Change the oil after every 25 hours of
operation or at least once a year if the
tractor is not used for 25 hours in one
year,,
Check the crankcase oil level before start-
ing the engine and after each eight (8)
hours of operation° Tighten oil fill cap/dip-
stick securely each time you check the oil
level,
TO CHANGE ENGINE OIL
Determine temperature range expected
before oil change, All oil must meet API
service classification SF, SG or SH;
• Be sure tractor is on level surface,
Oil will drain more freely when warm.
° Catch oil in a suitable container°
o Remove oil fill cap/dipstick. Be careful
not to allow dirt to enter the engine
when changing Clio
• Remove drain ptugo
o After oil has drained completely, replace
oil drain plug and tighten securely.
o Refill engine with oil through oil fill dip-
stick tube, Pour slowly. Do not overfill.,
For approximate capacity see "PROD-
UCT SPECIFICATIONS" on page 5 of
this manual°
o Use gauge on oil fill cap/dipstick for
checking level Be sure dipstick cap is
tightened securely for accurate reading.
Keep oil at "FULL" line on dipstick.
Oil Fill
"--CaptDipstick
/
,.,,,.
Oil Drain
/" Plug
AIR FILTER
Your engine will not run properly using a
dirty air filter. Clean the foam pre-cleaner
after every 25 hours of operation or every
season. Service paper cartridge every 100
hours of operation or every season,
whichever occurs first,,
Service air cleaner more often under dusty
conditions.
° Remove knob(s) and cover.
TO SERVICE PRE-CLEANER
° Slide foam pre-cleaner off cartridge.
o Wash it in liquid detergent and water_
° Squeeze it dry in a clean cloth.
o Saturate it in engine oil. Wrap it in clean,
absorbent cloth and squeeze to remove
excess oil
o If very dirty or damaged, replace pre-
cleaner,
o Reinstall pre-cleaner over cartridge_
o Reinstall cover and secure with knob(s).
TO SERVICE CARTRIDGE
= Remove cartridge nut.
- Carefully remove cartridge to prevent
debris from entering carburetor. Clean
base carefully to prevent debris from
entering carburetor_
= Clean cartridge by tapping gently on flat
surface_ If very dirty or damaged,
replace cartridge.
19
Loading ...
Loading ...
Loading ...