Loading ...
Loading ...
Loading ...
See Storage Instructions for additional
information° Never use engine or carbure-
tor cleaner products in the fuel tank or per-
nent damage may occur.,
CAUTION: Fill to bottom of gas tank
filler neck,. Do not overfill Wipe off any
spilled oil or fuel Do not store, spill or use
gasoline near an open flame,.
TO START ENGINE
When starting the engine for the first time
or if the engine has run out of fuel, it will
take extra cranking time to move fuel from
the tank to the engine.
o Sit on seat in operating position,
depress clutch/brake pedal and set
parking brake.
o Place gear shift lever in neutral (N) posi-
tion.
o Move attachment clutch to "DISEN-
GAGED" position°
o Move throttle control to choke position.
NOTE: Before starting, read the warm
and cold starting procedures below.
o Insert key into ignition and turn key
clockwise to "START" position and
release key as soon as engine starts..
Do not run starter continuously for more
than fifteen seconds per minute,. If the
engine does not start after several
attempts, move throttle control to fast
position, wait a few minutes and try
again,. If engine still does not start,
move the throttle control back to the
choke position and retry.
WARM WEATHER STARTING (50 ° F
AND ABOVE)
o When engine starts, move the throttle
control to the fast position.
o The attachments and ground drive can
now be used,. If the engine does not
accept the load, restart the engine and
allow it to warm up for one minute using
the choke as described above.
COLD WEATHER STARTING ( 50 ° F AND
BELOW)
o When engine starts, allow engine to run
with the throttle control in the choke
position until the engine runs roughly,
then move throttle control to fast posi-
tion_ This may require an engine warm-
up period from several seconds to sev-
eral minutes, depending on the temper-
ature.
o The attachments can also be used dur-
ing the engine warm-up period°
NOTE: if at a high altitude (above 3000
feet) or in cold temperatures (below 32 F)
the carburetor fuel mixture may need to be
adjusted for best engine performance°
See 'q'O ADJUST CARBURETOR" in the
Service and Adjustments section of this
.manual,
MOWIING TIIPS
• Tire chains cannot be used when the
mower housing is attached to tractor.
o Mower should be properly leveled for
best mowing performance° See 'qO
LEVEL MOWER HOUSING" in the
Service and Adjustments section of this
manual.
o The left hand side of mower should be
used for trimming°
o Drive so that clippings are discharged
onto the area that has been cut. Have
the cut area to the right of the machine°
This will result in a more even distribu-
tion of clippings and more uniform cut-
ting,
o When mowing large areas, start by turn-,
ing to the right so that clippings will dis-
charge away from shrubs, fences, drive-
ways, etco After one or two rounds,
mow in the opposite direction making
left hand turns until finished
f
o tf grass is extremely tall, it should be
mowed twice to reduce load and possi-
ble fire hazard from dried clippings.
Make first cut relatively high; the second
to the desired height°
o Do not mow grass when it is wet. Wet
grass will plug mower and leave unde-
sirable clumps. Allow grass to dry
before mowing_
o Always operate engine at full throttle
when mowing to assure better mowing
performance and proper discharge of
material, Regulate ground speed by se-
lecting a low enough gear to give the
mower the best cutting performance as
well as the quality of cut desired.
o When operating attachments, select a
ground speed that will suit the terrain
and give best performance of the at-
tachment being used_
15
Loading ...
Loading ...
Loading ...